ADM8845
PIN CONFIGURATION AND FUNCTION DESCRIPTION
PIN 1
INDICATOR
12 CTRL2
11 C2–
V
1
2
3
4
OUT
C2+
ADM8845
TOP VIEW
(Not to Scale)
I
10 GND
SET
FB1
9 FB6
Figure 2. Pin Configuration
Table 3. Pin Function Descriptions
Pin No. Mnemonic Function
1
VOUT
Charge Pump Output. A 2.2 µF capacitor to ground is required on this pin. Connect VOUT to the anodes of all
the LEDs.
2
3
C2+
ISET
Flying Capacitor 2 Positive Connection.
Bias Current Set Input. The current flowing through RSET, ISET, is gained up by 120 to give the ILED current.
Connect RSET to GND to set the bias current as VSET/RSET. Note that VSET = 1.18 V.
4–9
FB1–FB6
LED1–LED6 Cathode Connection and Charge Pump Feedback. The current flowing in these LEDs is 120 times
the current flowing through RSET, ISET. When using fewer than six LEDs, this pin can be left unconnected or
connected to GND.
10
11
12
13
14
15
16
-
GND
C2−
CTRL2
CTRL1
C1−
VCC
Device Ground Pin.
Flying Capacitor 2 Negative Connection.
Digital Input. 3 V CMOS Logic. Used with CTRL1 to control the shutdown operation of the main and sub LEDs.
Digital Input. 3 V CMOS Logic. Used with CTRL2 to control the shutdown operation of the main and sub LEDs.
Flying Capacitor 1 Negative Connection.
Positive Supply Voltage Input. Connect this pin to a 2.6 V to 5.5 V supply with a 4.7 µF decoupling capacitor.
Flying Capacitor 1 Positive Connection.
C1+
EP
Expose Paddle. Connect the exposed paddle to GND.
Rev. 0 | Page 5 of 20