Low Cost Microprocessor
System Hardware Monitor
a
ADM9240
FEATURES
P RO D UCT D ESCRIP TIO N
Six Direct Voltage Measurem ent Inputs (Including Tw o
Processor Core Voltages) w ith On-Chip Attenuators
On-Chip Tem perature Sensor
T he ADM9240 is a complete system hardware monitor for
microprocessor-based systems, providing measurement and
limit comparison of up to four power supplies and two proces-
sor core voltages, plus temperature, two fan speeds and chassis
intrusion. Measured values can be read out via an I2C-compat-
ible serial System Management Bus, and values for limit com-
parisons can be programmed in over the same serial bus. T he
high speed successive approximation ADC allows frequent
sampling of all analog channels to ensure a fast interrupt
response to any out-of-limit measurement.
Five Digital Inputs for VID Bits
Fully Supports Intel’s LANDesk Client Manager (LDCM)
Register-Com patible w ith LM7x Products
Tw o Fan Speed Monitoring Inputs
I2C® Com patible System Managem ent Bus (SMBus)
Chassis Intrusion Detect
Interrupt Output
Program m able RESET I/ O Pin
Shutdow n Mode to Minim ize Pow er Consum ption
Lim it Com parison of all Monitored Values
T he ADM9240’s 2.85 V to 5.75 V supply voltage range, low
supply current and I2C compatible interface, make it ideal for a
wide range of applications. T hese include hardware monitoring
and protection applications in personal computers, electronic
test equipment and office electronics.
APPLICATIONS
Netw ork Servers and Personal Com puters
Microprocessor-Based Office Equipm ent
Test Equipm ent and Measuring Instrum ents
FUNCTIO NAL BLO CK D IAGRAM
V
CC
VID0
NTEST_OUT/A0
A1
SERIAL BUS
ADDRESS
REGISTER
VID1
VID2
VID3
VID0 - 3 AND
FAN DIVISOR
REGISTERS
SERIAL BUS
INTERFACE
SDA
SCL
VID4 AND
DEVICE ID
REGISTER
VALUE AND LIMIT
REGISTERS
VID4
LIMIT
COMPARATORS
FAN1
FAN2
FAN SPEED
COUNTER
CI
INTERRUPT
STATUS
REGISTERS
ADDRESS
POINTER
REGISTER
+V
CCP1
INT MASK
+2.5V
IN
IN
TEMPERATURE
CONFIGURATION
REGISTER
REGISTERS
+3.3V
+5V
INT
INPUT
ATTENUATORS
AND
ANALOG
MULTIPLEXER
CONFIGURATION
REGISTER
IN
9-BIT ADC
+12V
IN
ANALOG
OUTPUT REGISTER
AND 8-BIT DAC
NTEST_IN/AOUT
+V
CCP2
RESET
BANDGAP
TEMPERATURE
SENSOR
CHASSIS
INTRUSION
CLEAR REGISTER
ADM9240
GNDA
GNDD
I2C is a registered trademark of Philips Corporation.
REV. 0
Inform ation furnished by Analog Devices is believed to be accurate and
reliable. However, no responsibility is assum ed by Analog Devices for its
use, nor for any infringem ents of patents or other rights of third parties
which m ay result from its use. No license is granted by im plication or
otherwise under any patent or patent rights of Analog Devices.
One Technology Way, P.O. Box 9106, Norw ood, MA 02062-9106, U.S.A.
Tel: 781/ 329-4700
Fax: 781/ 326-8703
World Wide Web Site: http:/ / w w w .analog.com
© Analog Devices, Inc., 1998