ADL5365
5 V PERFORMANCE
VS = 5 V, IS = 95 mA, TA = 25°C, fRF = 1900 MHz, fLO = 1697 MHz, LO power = 0 dBm, VGS0 = VGS1 = 0 V, and ZO = 50 Ω, unless
otherwise noted.
Table 3.
Parameter
Test Conditions\Comments
Min Typ
Max Unit
DYNAMIC PERFORMANCE
Power Conversion Loss
Voltage Conversion Loss
SSB Noise Figure
Including 1:1 IF port transformer and PCB loss
ZSOURCE = 50 Ω, differential ZLOAD = 50 Ω differential
6.5
27
7.3
8.4
dB
dB
dB
dB
8.3
18.5
SSB Noise Figure Under Blocking
5 dBm blocker present 10 MHz from wanted RF input,
LO source filtered
fRF1 = 1899.5 MHz, fRF2 = 1900.5 MHz, fLO = 1697MHz,
each RF tone at 0 dBm
fRF1 = 1950 MHz, fRF2 = 1900 MHz, fLO = 1697 MHz,
each RF tone at 0 dBm
Input Third-Order Intercept (IIP3)
Input Second-Order Intercept (IIP2)
36
67
dBm
dBm
Input 1 dB Compression Point (IP1dB)1 Exceeding 20 dBm RF power results in damage to the device
25
dBm
dBm
dBm
dBc
dBc
dBc
LO-to-IF Leakage
LO-to-RF Leakage
RF-to-IF Isolation
IF/2 Spurious
Unfiltered IF output
−18
−33
−50
−65
−71
0 dBm input power
0 dBm input power
IF/3 Spurious
POWER SUPPLY
Positive Supply Voltage
Quiescent Current
4.5
5
95
5.5
V
mA
Resistor programmable
1Exceeding 20 dBm RF power results in damage to the device.
3.3 V PERFORMANCE
VS = 3.3 V, IS = 56 mA, TA = 25°C, fRF = 1900 MHz, fLO = 1697 MHz, LO power = 0 dBm, R9 = 226 Ω, VGS0 = VGS1 = 0 V, and ZO = 50 Ω,
unless otherwise noted.
Table 4.
Parameter
Test Conditions/Comments
Min
Typ
Max
Unit
DYNAMIC PERFORMANCE
Power Conversion Loss
Voltage Conversion Loss
SSB Noise Figure
Including 1:1 IF port transformer and PCB loss
ZSOURCE = 50 Ω, differential ZLOAD = 50 Ω differential
7.4
7.1
8.4
32
dB
dB
dB
dBm
Input Third-Order Intercept (IIP3)
fRF1 = 1899.5 MHz, fRF2 = 1900.5 MHz, fLO = 1697 MHz,
each RF tone at 0 dBm
Input Second-Order Intercept (IIP2)
fRF1 = 1950 MHz, fRF2 = 1900 MHz, fLO = 1697 MHz,
each RF tone at 0 dBm
58
dBm
POWER INTERFACE
Supply Voltage
Quiescent Current
Power-Down Current
3.0
3.3
56
150
3.6
V
mA
μA
Resistor programmable
Device disabled
Rev. 0 | Page 4 of 24