ADCLK948
ABSOLUTE MAXIMUM RATINGS
DETERMINING JUNCTION TEMPERATURE
Table 5.
To determine the junction temperature on the application
printed circuit board (PCB), use the following equation:
Parameter
Rating
Supply Voltage
VCC − VEE
Input Voltage
CLK0, CLK1, CLK0, CLK1, IN_SEL
6 V
TJ = TCASE + (ΨJT × PD)
where:
VEE − 0.5 V to
VCC + 0.5 V
TJ is the junction temperature (°C).
T
CASE is the case temperature (°C) measured by the customer at
CLK0, CLK1, CLK0, CLK1 to VTx Pin (CML,
LVPECL Termination)
40 mA
the top center of the package.
ΨJT is from Table 6.
PD is the power dissipation.
CLK0, CLK1 to CLK0, CLK1
1.8 V
2 V
Input Termination, VTx to CLK0, CLK1, CLK0,
and CLK1
Values of θJA are provided for package comparison and PCB
design considerations. θJA can be used for a first-order approxi-
mation of TJ by the equation
Maximum Voltage on Output Pins
Maximum Output Current
Voltage Reference (VREFx)
Operating Temperature Range
Ambient
VCC + 0.5 V
35 mA
VCC to VEE
TJ = TA + (θJA × PD)
−40°C to +85°C
150°C
−65°C to +150°C
where TA is the ambient temperature (°C).
Junction
Storage Temperature Range
Values of θJB are provided in Table 6 for package comparison
and PCB design considerations.
Stresses above those listed under Absolute Maximum Ratings
may cause permanent damage to the device. This is a stress
rating only; functional operation of the device at these or any
other conditions above those indicated in the operational
section of this specification is not implied. Exposure to absolute
maximum rating conditions for extended periods may affect
device reliability.
ESD CAUTION
THERMAL PERFORMANCE
Table 6.
Parameter
Symbol
Description
Value1
Unit
Junction-to-Ambient Thermal Resistance
θJA
Still Air
0 m/sec Air Flow
Moving Air
Per JEDEC JESD51-2
Per JEDEC JESD51-6
49.8
°C/W
θJMA
1 m/sec Air Flow
2.5 m/sec Air Flow
43.5
39.0
°C/W
°C/W
Junction-to-Board Thermal Resistance
Moving Air
θJB
Per JEDEC JESD51-8
1 m/sec Air Flow
Junction-to-Case Thermal Resistance
Moving Air
Die-to-Heatsink
Junction-to-Top-of-Package Characterization Parameter
Still Air
30.ꢀ
8.8
°C/W
°C/W
°C/W
θJC
Per MIL-STD 883, Method 1012.1
Per JEDEC JESD51-2
ΨJT
0 m/sec Air Flow
0.ꢀ
1 Results are from simulations. The PCB is a JEDEC multilayer type. Thermal performance for actual applications requires careful inspection of the conditions in the
application to determine if they are similar to those assumed in these calculations.
Rev. 0 | Page 5 of 12