5秒后页面跳转
AD5539SQ PDF预览

AD5539SQ

更新时间: 2024-02-23 12:19:30
品牌 Logo 应用领域
亚德诺 - ADI 运算放大器放大器电路
页数 文件大小 规格书
16页 475K
描述
Ultrahigh Frequency Operational Amplifier

AD5539SQ 技术参数

是否无铅: 含铅是否Rohs认证: 不符合
生命周期:Active零件包装代码:DIP
包装说明:DIP,针数:14
Reach Compliance Code:unknown风险等级:5.71
Is Samacsys:N商用集成电路类型:VIDEO AMPLIFIER
JESD-30 代码:R-GDIP-T14JESD-609代码:e0
长度:19.43 mm信道数量:1
功能数量:1端子数量:14
最高工作温度:125 °C最低工作温度:-55 °C
封装主体材料:CERAMIC, GLASS-SEALED封装代码:DIP
封装形状:RECTANGULAR封装形式:IN-LINE
峰值回流温度(摄氏度):NOT SPECIFIED认证状态:COMMERCIAL
座面最大高度:5.08 mm最大供电电压 (Vsup):10 V
最小供电电压 (Vsup):4.5 V表面贴装:NO
温度等级:MILITARY端子面层:TIN LEAD
端子形式:THROUGH-HOLE端子节距:2.54 mm
端子位置:DUAL处于峰值回流温度下的最长时间:NOT SPECIFIED
宽度:7.62 mmBase Number Matches:1

AD5539SQ 数据手册

 浏览型号AD5539SQ的Datasheet PDF文件第10页浏览型号AD5539SQ的Datasheet PDF文件第11页浏览型号AD5539SQ的Datasheet PDF文件第12页浏览型号AD5539SQ的Datasheet PDF文件第13页浏览型号AD5539SQ的Datasheet PDF文件第14页浏览型号AD5539SQ的Datasheet PDF文件第16页 
AD5539  
T he transient response of the signal channel at VX = +2 V,  
Y = VOUT = + or –1 V is shown in Figure 46; with the VCA  
V
driving a 75 load. T he rise and fall times are both approxi-  
mately 7 ns.  
A few final circuit details: in general, the control amplifier com-  
pensation capacitor for Pin 2, CC, must have a minimum value  
of 3000 pF (3 nF) to provide both circuit stability and maximum  
control bandwidth. However, if the maximum control bandwidth  
is not needed, then it is advisable to use a larger value of CC,  
with typical values between 0.01 and 0.1 µF. Like many aspects  
of design, the value of CC will be a tradeoff: higher values of CC  
will lower the high frequency distortion, reduce the high fre-  
quency crosstalk and improve the signal channel phase response.  
Conversely, lower values of CC will provide a higher control  
channel bandwidth at the expense of degraded linearity in the  
output response when amplitude modulating a carrier signal.  
Figure 46. Transient Response of the Voltage-Controlled  
Am plifier VX = +2 Volts, VY = ±1 Volt  
mic node, the settling time of the control channel with a pulse  
input will vary with different control input step levels.  
T he control channel bandwidth will vary in inverse proportion to  
the value of CC, providing a typical bandwidth of 2 MHz with a  
CC of 0.01 µF and a VX voltage of +1.7 volts.  
Diode D1 clamps the logarithmic control node at Pin 2 of the  
AD539, (preventing this point from going too negative); this  
diode helps decrease the circuit recovery time when the control  
input goes below ground potential.  
Both the bandwidth and pulse response of the control channel  
can be further increased by using a feedforward capacitor, Cff,  
with a value between 5 and 20 percent of CC. Cff should be care-  
fully adjusted to give the best pulse response for a particular step  
input applied to the control channel. Note that since Cff is con-  
nected between a linear control input (Pin 1) and a logarith-  
TH E AD 539/5539 CO MBINATIO N AS A FAST, LO W  
FEED TH RO UGH , VID EO SWITCH  
Figure 47 shows how the AD539/5539 combination can be used  
to create a fast video speed switch suitable for many high fre-  
Figure 47. An Analog Multiplier Video Switch  
REV. B  
–15–  

AD5539SQ 替代型号

型号 品牌 替代类型 描述 数据表
AD5539JN ADI

功能相似

Ultrahigh Frequency Operational Amplifier
HA3-2839-5 HARRIS

功能相似

600MHz, Very High Slew Rate Operational Amplifier

与AD5539SQ相关器件

型号 品牌 描述 获取价格 数据表
AD5539SQ/883B ADI Ultrahigh Frequency Operational Amplifier

获取价格

AD5541 ADI 5 V, Serial-Input Voltage-Output, 16-Bit DACs

获取价格

AD5541_12 ADI 2.7 V to 5.5 V, Serial-Input, Voltage-Output, 16-Bit DACs

获取价格

AD5541_15 ADI 2.7 V to 5.5 V, Serial-Input, Voltage-Output, 16-Bit DACs

获取价格

AD5541A ADI 2.7 V to 5.5 V, Serial-Input, Voltage-Output, 16-/12-Bit nanoDACs in LFCSP

获取价格

AD5541AACPZ ADI 2.7 V to 5.5 V, Serial-Input, Voltage-Output, 16-/12-Bit nanoDACs in LFCSP

获取价格