PRODUCT DATASHEET
AAT2601178
Total Power Solution for Portable Applications
General Description
Features
•
•
The AAT2601 is a member of AnalogicTech’s Total Power
Management ICTM (TPMICTM) product family. It contains
a single-cell Lithium Ion/Polymer battery charger, a fully
integrated step-down converter and 5 low dropout (LDO)
regulators. The device also includes 2 load switches for
dynamic power path/sleep mode operation, making it
ideal for small handheld portable GSM or CDMA mobile
telephones.
Voltage Regulator VIN Range: 4.5V to 6V
Complete Power Integration
Integrated Load Switches to Power Converters from
AC Adapter or Battery Automatically
Low Standby Current
▪
•
•
170μA (typ) w/ Buck (Core), LDO1 (PowerDigital),
and LDO2 (PowerAnalog) Active, No Load
One Step-Down Buck Converter (Core)
▪
1.8V, 300mA Output
1.5MHz Switching Frequency
▪
The battery charger is a complete thermally regulated
constant current/constant voltage linear charger. It
includes an integrated pass device, reverse blocking pro-
tection, high accuracy current and voltage regulation,
charge status, and charge termination. The charging
current, charge termination current, and recharge volt-
age are programmable with an external resistor and/or
by a standard I2C interface.
▪
Fast Turn-On Time (120μs typ)
▪
Five LDOs Programmable with I2C
•
LDO1: 3.0V, 300mA (PowerDigital)
LDO2: 3.0V, 150mA (PowerAnalog or PLL)
LDO3: 3.0V, 150mA (TCXO)
LDO4: 3.0V, 150mA (TX)
LDO5: 3.0V, 150mA (RX)
PSRR: 60dB@10kHz
Noise: 50μVrms for LDO3, LDO4, and LDO5
▪
▪
▪
▪
▪
The step-down DC/DC converter is integrated with internal
compensation and operates at a switching frequency of
1.5MHz, thus minimizing the size of external components
while keeping switching losses low and efficiency greater
than 95%. All LDO output voltages are programmable
using the I2C interface.
▪
▪
•
One Battery Charger
Digitized Thermal Regulation
Charge Current Programming up to 1.4A
Charge Current Termination Programming
Automatic Trickle Charge for Battery Preconditioning
▪
▪
▪
▪
The five LDOs offer 60dB power supply rejection ratio
(PSRR) and low noise operation making them suitable for
powering noise-sensitive loads.
(2.8V Cutoff)
•
•
•
•
•
Adapter OK (ADPP) and Reset (RESET) Timer Outputs
Separate Enable Pins for Supply Outputs
Over-Current Protection
Over-Temperature Protection
5x5mm TQFN55-36 Package
All six voltage regulators operate with low quiescent cur-
rent. The total no load current when the step-down con-
verter and 2 LDOs are enabled is only 170μA.
The AAT2601 is available in a thermally enhanced low
profile 5x5x0.8mm 36-pin TQFN package.
Applications
•
•
•
•
•
Digital Cameras
GSM or CDMA Cellular Phones
Handheld Instruments
PDAs and Handheld Computers
Portable Media Players
w w w . a n a l o g i c t e c h . c o m
2601.2008.01.1.0
1