5秒后页面跳转
A3212LLHLT PDF预览

A3212LLHLT

更新时间: 2024-02-15 14:10:36
品牌 Logo 应用领域
急速微 - ALLEGRO 模拟IC开关信号电路光电二极管信息通信管理
页数 文件大小 规格书
13页 381K
描述
MICROPOWER, ULTRA-SENSITIVE HALL-EF FECT SWITCH

A3212LLHLT 技术参数

是否Rohs认证:不符合生命周期:Obsolete
零件包装代码:SIP包装说明:,
针数:3Reach Compliance Code:compliant
HTS代码:8542.39.00.01风险等级:5.64
Is Samacsys:N模拟集成电路 - 其他类型:ANALOG CIRCUIT
JESD-30 代码:R-PSSO-G3JESD-609代码:e0
长度:4.105 mm功能数量:1
端子数量:3最高工作温度:150 °C
最低工作温度:-40 °C封装主体材料:PLASTIC/EPOXY
封装形状:RECTANGULAR封装形式:SMALL OUTLINE
峰值回流温度(摄氏度):240认证状态:Not Qualified
座面最大高度:1.57 mm最大供电电压 (Vsup):3.5 V
最小供电电压 (Vsup):2.5 V标称供电电压 (Vsup):2.75 V
表面贴装:YES技术:BICMOS
温度等级:AUTOMOTIVE端子面层:Tin/Lead (Sn/Pb)
端子形式:GULL WING端子节距:1.27 mm
端子位置:SINGLE处于峰值回流温度下的最长时间:NOT SPECIFIED
宽度:3.035 mmBase Number Matches:1

A3212LLHLT 数据手册

 浏览型号A3212LLHLT的Datasheet PDF文件第4页浏览型号A3212LLHLT的Datasheet PDF文件第5页浏览型号A3212LLHLT的Datasheet PDF文件第6页浏览型号A3212LLHLT的Datasheet PDF文件第8页浏览型号A3212LLHLT的Datasheet PDF文件第9页浏览型号A3212LLHLT的Datasheet PDF文件第10页 
3212  
MICROPOWER,  
ULTRA-SENSITIVE  
HALL-EFFECT SWITCH  
FUNCTIONAL DESCRIPTION (cont'd)  
Operation. The output of this device switches low (turns on)  
when a magnetic field perpendicular to the Hall sensor exceeds  
the operate point BOPS (or is less than BOPN). After turn-on, the  
output is capable of sinking up to 1 mA and the output voltage  
is VOUT(ON). When the magnetic field is reduced below the  
release point BRPS (or increased above BRPN), the device output  
switches high (turns off). The difference in the magnetic operate  
and release points is the hysteresis (Bhys) of the device. This  
built-in hysteresis allows clean switching of the output even  
in the presence of external mechanical vibration and electrical  
noise.  
OUTPUT OFF  
5 V  
MAX  
B
B
OPN  
OPS  
As used here, negative flux densities are defined as less than  
zero (algebraic convention), i.e., -50 G is less than +10 G.  
Applications. Allegro's pole-independent sensing technique  
allows for operation with either a north pole or south pole mag-  
net orientation, enhancing the manufacturability of the device.  
The state-of-the-art technology provides the same output polarity  
for either pole face.  
B
B
RPS  
RPN  
OUTPUT ON  
0
0
-B  
+B  
MAGNETIC FLUX  
Dwg. GH-043-1  
It is strongly recommended that an external bypass capacitor  
be connected (in close proximity to the Hall sensor) between the  
supply and ground of the device to reduce both external noise  
and noise generated by the chopper-stabilization technique. This  
is especially true due to the relatively high impedance of battery  
supplies.  
OUTPUT  
The simplest form of magnet that will operate these devices  
is a bar magnet with either pole near the branded surface of the  
device. Many other methods of operation are possible. Exten-  
sive applications information for Hall-effect sensors is available  
in:  
10 pF  
X
Hall-Effect IC Applications Guide, Application Note 27701;  
Hall-Effect Devices: Soldering, Gluing, Potting, Encapsu-  
lating, and Lead Forming, Application Note 27703.1;  
Soldering of Through-Hole Hall-Sensor Dervices, Application  
Note 27703; and  
SUPPLY  
(3 V BATTERY)  
0.1 µF  
Dwg. EH-013-2  
Soldering of Surface-Mount Hall-Sensor Devices, Application  
Note 27703.2.  
All are provided at  
www.allegromicro.com  
www.allegromicro.com  
7

与A3212LLHLT相关器件

型号 品牌 描述 获取价格 数据表
A3212LLHLT-T ALLEGRO MICROPOWER, ULTRA-SENSITIVE HALL-EF FECT SWITCH

获取价格

A3212LLHLX-T ALLEGRO Analog Circuit,

获取价格

A3212LUA ALLEGRO MICROPOWER, ULTRA-SENSITIVE HALL-EF FECT SWITCH

获取价格

A3212LUA SANKEN Analog Circuit, 1 Func, BICMOS, PSIP3, ULTRA MINI, SIP-3

获取价格

A3212LUA2 ALLEGRO Analog Circuit, 1 Func, BICMOS, PSIP3, SIP-3

获取价格

A3212LUA-C ALLEGRO Sensor/Transducer, Open-drain, BICMOS, 3 Pin, Plastic/epoxy,

获取价格