A2 & LP2
Single RowTerminal Blocks
Mounting Options Inches (Millimeters)
Right Angle Bends
07Terminal Bend Configurations
Right angle terminals are offered on the A2 & LP2. Configurations are
defined in these dimensions: X = pin extension beyond the block base;
Z = length from block base to centerline of the terminal tip. Standard
bends consist of the X and Z dimensions shown in the chart. Specify by
adding the selected Bend Option Code to the terminal part number.
04Terminal Bend Configurations
X
Available with
insulator base
Bend Option Code
(minimum)
Z
R35
R42
R46
R50
R53
R66
R75
0.01
0.50
0.43
0.39
0.35
0.32
0.19
0.10
Yes
Yes
Yes
No
No
No
No
0.08
0.12
0.16
X
Available with
insulator base
Bend Option Code
(minimum)
Z
0.19
R35
R42
R46
R50
0.01
0.08
0.12
0.16
0.23
0.16
0.12
0.08
No
No
No
No
0.32
0.41
Dimensions in inches. To convert to millimeters, multiply by 25.4.
Dimensions in inches. To convert to millimeters, multiply by 25.4.
Drilled Right Angle
Angle Brackets
Option DR
Counterbored holes across mount ends of block enable fastening
with two screws at right angles to normal mount position.
Option AB
Angle brackets enable block to be fastened at right angles to normal
mount position. Bulk part number 2AB-J.
Mounting Plates
Options MP
MP Metal inserts with 0.150” dia. hole accept #6 screw.
Bulk part number 2MP-J.
EATON www.eaton.com
11