Document Number: MMPF0200
Rev. 7, 7/2019
NXP Semiconductors
Data Sheet: Technical Data
12 channel configurable power
management integrated circuit
PF0200
The PF0200 Power Management Integrated Circuit (PMIC) provides a highly
programmable/ configurable architecture, with fully integrated power devices
and minimal external components. With up to four buck converters, one boost
regulator, six linear regulators, RTC supply, and coin-cell charger, the PF0200
can provide power for a complete system, including applications processors,
memory, and system peripherals, in a wide range of applications. With on-chip
One Time Programmable (OTP) memory, the PF0200 is available in pre-
programmed standard versions, or non-programmed to support custom
programming. The PF0200 is especially suited to the i.MX 6SoloLite,
POWER MANAGEMENT
i.MX 6Solo and i.MX 6DualLite versions of the i.MX 6 family of devices and is
supported by full system level reference designs, and pre-programmed
versions of the device. This device is powered by SMARTMOS technology.
EP SUFFIX (E-TYPE)
ES SUFFIX (WF-TYPE)
56 QFN 8X8
56 QFN 8X8
98ASA00405D
98ASA00589D
Features:
Applications
• Three to four buck converters, depending on configuration
• Boost regulator to 5.0 V output
• Six general purpose linear regulators
• Programmable output voltage, sequence, and timing
• OTP (One Time Programmable) memory for device configuration
• Coin cell charger and RTC supply
• Tablets
• IPTV
• Industrial Control
• Medical monitoring
• Home automation/ alarm/ energy management
• DDR termination reference voltage
• Power control logic with processor interface and event detection
• I2C control
• Individually programmable ON, OFF, and Standby modes
PF0200
VREFDDR
i.MX6X
DDR MEMORY
INTERFACE
DDR Memory
SW3A/B
SW1A/B
SW2
Processor Core
Voltages
External AMP
Microphones
Speakers
SATA - FLASH
SD-MMC/
NAND Mem.
SATA
HDD
NAND
- NOR
Interfaces
SWBST
Audio
Codec
Parallel control/GPIOS
I2C Communication
Control Signals
I2C Communication
Sensors
VGEN1
VGEN2
VGEN3
VGEN4
VGEN5
VGEN6
Camera
Camera
GPS
MIPI
uPCIe
WAM
GPS
MIPI
HDMI
LDVS Display
USB
Ethernet
CAN
LICELL
Charger
COINCELL
Main Supply
Front USB
POD
Rear Seat
Infotaiment
Rear USB
POD
Cluster/HUD
Figure 1. Simplified application diagram
© NXP B.V. 2019.