408-9167
3. Holding the connector body and ferrule in place, actuate the tool through a complete cycle.
NOTE
Apply sufficient pressure on cable so shoulder on the connector body maintains contact against locator as shown in Figure 3.
4. Remove the crimped connector from the tool.
4. MAINTENANCE AND INSPECTION PROCEDURE
4.1. Daily Maintenance
TE Connectivity recommends that each operator of the dies be made aware of, and responsible for, the
following steps of daily maintenance:
1. Remove dust, moisture, and other contaminants with a clean brush, or a soft, lint-free cloth. Do not
use objects that could damage the dies.
2. Make sure the proper die holding screws are in place and secured with the proper retaining rings.
Check die alignment and tighten die holding screws at least twice daily.
3. Make certain all surfaces are protected with a THIN coat of any good SAE 20 motor oil. Do not oil
excessively.
4. When the dies are not in use, mate and store them in a clean, dry area.
4.2. Inspection
Regular inspections should be performed by quality control personnel. A record of scheduled inspections
should remain with the dies and/or be supplied to supervisory personnel responsible for the dies. Though
recommendations call for at least one inspection a month, the inspection frequency should be based on the
amount of use, ambient working conditions, operator training and skill, and established company standards.
These inspections should be performed in the following sequence:
Visual Inspection
1. Remove all lubrication and accumulated film by immersing the dies in a suitable commercial
degreaser that will not affect paint or plastic material.
2. Make sure all die holding screws, retaining rings, and die components are in place. Refer to the parts
listed in Figure 5 if replacements are necessary.
3. Check all bearing surfaces for wear. Remove and replace worn components.
4. Inspect the crimp area for flattened, chipped, cracked, worn, or broken areas. If damage is evident,
the dies must be repaired before returning them to service. See Section 5, REPLACEMENT AND
Gaging the Crimping Chamber
This inspection requires the use of a plug gage conforming to the dimensions provided in Figure 4. TE
does not manufacture or market these gages.Refer to Instruction Sheet 408-7424 for more information on
plug gages. Proceed as follows:
1. Mate the dies until it is evident that they have bottomed. Hold the dies in this position with a pressure
of approximately 69 kPa [10 psi].
2. Align the GO element with the appropriate crimping area. Push element straight into the crimping area
without using force. The GO element must pass completely through the crimping area as shown in
Figure 4.
3. Now align the NO-GO element and try to insert it straight into the same crimping chamber. The NO-
GO element may start entry but must not pass completely through as shown in Figure 4.
4. Repeat Steps 2 and 3 for each crimp section listed in Figure 4.
If the crimping chamber conforms to the gage inspection, the dies are considered dimensionally correct
and should be lubricated with a THIN coat of any good SAE 20 motor oil. If not, the dies must be repaired
before returning them to service. See Section 5, REPLACEMENT AND REPAIR.
3 of 5
Rev B
5秒后页面跳转
深入解析CS8416引脚说明、参数、技术特点
TPA3116D2功放芯片参数详解、引脚说明
移位寄存器74HC165引脚说明、驱动程序示例解读
深入解析AD9833：DDS频率合成器的卓越性能与广泛应用
微信公众号
抖音公众号
浙公网安备 33010502006866号 浙ICP备10014259号-119
营业执照ICP证
数据手册
如果您发现信息不准确，
