Reference Only
Spec No. J(E)TE243A-0008A-01
8/9
DFE322512C Type 注意事項 Precautions
使用上の注意事項(安全対策) Noticeꢀ
6, 保管・運搬 Storage and Handling Requirements
1, 保管期間 Storage Period
納入後、6ヶ月以内にご使用下さい。
なお、6ヶ月を超える場合は、はんだ付け性をご確認の上ご使用ください。
Use the products within 6 months after delivered.
Solderability should be checked if this period is exceeded.
2, 保管方法 Storage Conditions
・当製品は、温度-10℃~+40℃、相対湿度15%~85%で、且つ、急激な温湿度の変化の
ない室内で保管ください。
硫黄・塩素ガス・酸など腐食性ガス雰囲気中で保管されますと、電極が酸化し、はんだ付け性不良が
生じたり、製品の巻線部分が腐食する等の原因となります。
・バルクの状態での保管は避けてください。バルクでの保管は製品同士あるいは製品と他の部品が
衝突し、コアカケや断線を生じることがあります。
・湿気、塵などの影響を避けるため、床への直置は避けパレットなどの上に保管ください。
・直射日光、熱、振動などが加わる場所での保管は避けてください。
• Products should be stored in the warehouse on the following conditions.
Temperature : -10 ~ 40°C
Humidity : 15 to 85% relative humidity No rapid change on temperature and humidity
Don't keep products in corrosive gases such as sulfur,
chlorine gas or acid, or it may cause oxidization of electrode, resulting in poor solderability.
• Products should not be stored on bulk packaging condition to prevent the chipping of the core and the
breaking of winding wire caused by the collision between the products.
• Products should be stored on the palette for the prevention of the influence from humidity, dust and so on.
• Products should be stored in the warehouse without heat shock, vibration, direct sunlight and so on.
3, 運搬 Handling Condition
過度の振動、衝撃は製品の信頼性を低下させる原因となりますので、取り扱いには充分注意をお願い
します。
Care should be taken when transporting or handling product to avoid excessive vibration or mechanical shock.
MURATA MFG.CO., LTD.