LMH34400
www.ti.com.cn
ZHCSMM2B –MARCH 2022 –REVISED MARCH 2023
6.5 Electrical Characteristics (continued)
VDD = 3.3 V, CPD (1) = 1 pF, EN = 0 V, IDC_EN = 3.3 V, RL = 100 Ω(Output is AC-coupled for AC performance parameters;
for DC performance parameters load is referenced to 1V), and TA = 25℃(unless otherwise noted)
PARAMETER
TEST CONDITIONS
MIN
TYP
MAX
UNIT
SHUTDOWN
1.2
1.5
1.4
1.6
65
1.7
IQ
Disabled quiescent current (EN = VDD
)
mA
µA
TA = –40°C
TA = 125°C
EN and IDC_EN pins input bias current
90
(1) Input capacitance of photodiode.
(2) Average of rising and falling slew rate.
(3) Pulse width extension measured at 50% of pulse height of square wave.
(4) Gain measured at the amplifier output pin when driving a 100-Ω resistive load. At higher resistor loads the gain increases.
(5) Photodiode anode biased to a negative voltage
(6) Photodiode cathode biased to a positive voltage
(7) Device cannot withstand continuous short-circuit.
(8) Enabling the ambient light cancellation loop adds noise to the system.
6.6 Electrical Characteristics: Logic Threshold and Switching Characteristics
VDD = 3.3 V, CPD ((1)) = 1 pF, EN = 0 V, IDC_EN = 3.3 V, RL = 100 Ω(Output is AC-coupled for AC performance parameters;
for DC performance parameters load is referenced to 1V), and TA = 25℃(unless otherwise noted)
PARAMETER
TEST CONDITIONS
MIN
TYP
MAX
UNIT
LOGIC THRESHOLD PERFORMANCE
Amplifier disabled above this voltage
Amplifier enabled below this voltage
1.6
1.2
2
V
V
EN control threshold voltage
0.8
Ambient light cancellation loop disabled
above this voltage
1.6
1.2
2
V
V
IDC_EN control threshold voltage
Ambient light cancellation loop enabled
below this voltage
0.8
EN CONTROL TRANSIENT PERFORMANCE
Ambient loop disabled, fIN = 25 MHz, VOUT
= 1 VPP, IDC = 0 µA
Enable transition-time (1% settling)
200
3.5
10
ns
ns
µs
ns
Ambient loop disabled, fIN = 25 MHz, VOUT
= 1 VPP, IDC = 0 µA
Disable transition-time (1% settling)
Enable transition-time (1% settling)
Disable transition-time (1% settling)
(1) Input capacitance of photodiode.
Ambient loop enabled, fIN = 25 MHz, VOUT
1 VPP, IDC = 100 µA
=
=
Ambient loop enabled, fIN = 25 MHz, VOUT
1 VPP, IDC = 100 µA
3.5
Copyright © 2023 Texas Instruments Incorporated
English Data Sheet: SBOSA56
6
Submit Document Feedback
Product Folder Links: LMH34400