X60250
®
Data Sheet
September 14, 2005
FN8146.1
PROGRAMMABLE VOLTAGE
REFERENCE APPLICATIONS
Micro Power Programmable Voltage
Reference
• Sensor Bias
FEATURES
• Variable DAC reference
• Linear Voltage Regulators
• DC/DC converters
• Voltage comparators
• Motor controllers
• 1.25V 1.0%, 20ppm/°C Tempco Reference
• Adjustable to ±0.25% Over the 0 to 1.25V Range
• 8 bit, 100kΩ XDCP on-chip
• Programmable Resolution of 4.9mV (255 steps)
• Extra Matched 100kΩ Resistor Available for
Increased Resolution Over a Smaller Range
• 2.7V to 5.5V Supply Range
• Amplifier biasing
DESCRIPTION
• 2-Wire Interface for Programming Reference
Setting
• Low Supply Current: 12µA in Normal Mode
• 8-pin TSSOP Package
• Programmable Reference
• NV Memory
The Intersil X60250 combines
a
temperature
compensated voltage reference with a Intersil Digitally
Controlled Potentiometer (XDCP) to provide a precision
adjustable reference with a range of 0.0V to 1.25V. The
device includes a serial bus interface to enable in-circuit
programming of the reference voltage.
• Pb-Free Plus Anneal Available (RoHS Compliant)
The XDCP contains a resistor chain with 255 taps to
provide 8 bits of digital adjustment to the reference
voltage. Non-volatile storage retains the digital wiper
setting, for permanent reference programming. An
additional matched 100kΩ resistor is available to
increase resolution of the output voltage while retaining
accuracy.
IC BLOCK DIAGRAM
VCC
VREFOUT
Pwr On Recall
1.25V
Reference
100K
VOUT
EE
PROM
R1
SCL
SDA
Serial
Interface
100kΩ
Digital Wiper
Control
GND
VREFL
CAUTION: These devices are sensitive to electrostatic discharge; follow proper IC Handling Procedures.
1-888-INTERSIL or 1-888-468-3774 | Intersil (and design) is a registered trademark of Intersil Americas Inc.
Copyright Intersil Americas Inc. 2005. All Rights Reserved
1
All other trademarks mentioned are the property of their respective owners.