WRE-YD-4W&WRF-YD-4W Series
General Specifications
Input Specifications
Voltage range
Efficiency
73% to 81%
12VDC, 9~18VDC
24VDC, 18~36VDC
48VDC, 36~72VDC
p(Pi) Network
Switching Frequency
Output Specifications
250KHz, typ. 100% load
Filter
Isolation Specifications
Voltage accuracy
±1%, max.
±1%
Voltage balance (Dual Output)
Ripple & noise (at 20MHz BW) 60mVp-p, max.
Rated voltage (60 sec)
Resistance
3000VDC
> 1000MOhm
120pF, typ.
Short circuit protection
Short circuit restart
Continuous
Automatic
Capacitance
Line voltage regulation
Load voltage regulation
Temperature coefficient
±0.5%, max.
±0.5%, max.
±0.02%/°C, typ.
Environmental Specifications
Operating temperature (ambient) -40°C ... +85°C
Storage temperature
Case temperature
Derating
-55°C ... +125°C
+100°C, max.
None required
Up to 90%
Physical Specifications
Dimensions
31.75x20.32x10.16mm
1.25x0.8x0.4inches
19g
Humidity (non-condensing)
Cooling
Weight
Free-air Convection
MTBF: > 1,036,000 hrs (MIL-HDBK-217F, Ground Benign, t=+25°C)
Case material
Nickel-Coated Copper
Specifications are subject to change without notification
TYPICAL CHARACTERISTICS
APPLICATION NOTE
Temperature Derating Graph
Requirement on output load
In order to ensure the product operate efficiently and reliably,in addition to a
max load(namely full load), a minimum load is specified for this kind of
DC/DC converter.Make sure the specified range of input voltage is not
exceeded,the minimum output load no less than 10% load.If the actual
load is less than the specified minimum load, the output ripple may increase
sharply while its efficiency and reliability will reduce greatly.If the actual
output power is very small,please add an appropriate resistor as extra
loading,or contact our company for other lower output power products.
Recommended Circuit
RECOMMENDED CIRCUIT
All the WRE_YD-4W&WRE_YD-4W Series have been tested according to
the following recommended testing circuit before leaving factory.This series
should be tested under load(See figure 1).
Output Graph
If you want to further decrease the input/output ripple,you can increase
capacitance properly or choose capacitors with low ESR. However, the
capacitance of the output filter capacitor must be proper. If the capacitance
is too big, a startup problem might arise. For every channel of output,
provided the safe and reliable operation is ensured, the greatest capacitance
of its filter capacitor sees (Table 1).
General:
Cin: 5V&12V 100μF
24V&48V 100μF-47μF
Cout: 10μF/100mA
Input current
While using unstable power source,please ensure the output voltage and
ripple voltage do not exceed indexes of the converter. Input current of
power supply should afford the startup current of this kind of DC/DC module
(See figure 2).
General:Ip≤1.4*Iin-max
No parallel connection or plug and play
http://www.microdc.cn
Technical Enquiries-Email:tech@microdc.cn Tel:0086-20-86000646
Page 2 of 3