WRE-YS-3W&WRF-YS -3W Series
OUTLINE DIMENSIONS & FOOTPRINT DETAILS
MECHANICAL DIMENSIONS
RECOMMENDED FOOTPRINT
Top view grid:2.54mm(0.1inch)
diameter:1.00mm(0.039inch)
Note:
Unit:mm[inch]
TUBE OUTLINE DIMENSIONS
Pin section tolerances:±0.10mm[±0.004inch]
General tolerances:±0.25mm[±0.010inch]
FOOTPRINT DETAILS
Single
Pin
1
Dual
-Vin(GND)
+Vin(Vcc)
CTRL
-Vin(GND)
+Vin(Vcc)
CTRL
NC
2
3
5
NC
6
+Vout
-Vout
+Vout
7
Common
-Vout
8
NC
NC=No Connection
Note:specifications can be changed any time without notice.
Note:
Unit :mm[inch]
General tolerances:±0.50mm[±0.020inch]
L=530mm[20.866inch] Tube Quantity: 22pcs
L=220mm[8.661inch] Tube Quantity:8pcs
When the environment temperature is higher than 71℃, the
product output power should be less then 60% of the rated
power.
No parallel connection or plug and play.
Note:
1. The load shouldn't be less than 10%, otherwise ripple will increase dramatically.
2. Operation under 10% load will not damage the converter; However, they may not meet all specification listed.
3. All specifications measured at Ta=25°C, humidity<75%, nominal input voltage and rated output load unless otherwise
specified.
4. In this datasheet, all the test methods of indications are based on corporate standards.
5. Only typical models listed, other models may be different, please contact our technical person for more details.
http://www.microdc.cn
Technical Enquiries-Email:tech@microdc.cn Tel:0086-20-86000646
Page 3 of 3