5秒后页面跳转
WRB1215YD-6W PDF预览

WRB1215YD-6W

更新时间: 2022-03-24 00:48:17
品牌 Logo 应用领域
MICRODC 输出元件输入元件
页数 文件大小 规格书
3页 1132K
描述
6W,WIDEINPUT, ISOLATED®ULATEDDUAL/SINGLEOUTPUTDC-DCCONVERTER

WRB1215YD-6W 数据手册

 浏览型号WRB1215YD-6W的Datasheet PDF文件第1页浏览型号WRB1215YD-6W的Datasheet PDF文件第3页 
WRA-YD-6WWRB-YD -6W Series  
TEMPERATURE CHARACTERISTICS  
TYPICAL CHARACTERISTICS  
Parameter  
Conditions  
Min.  
Typ.  
Max.  
Units  
Temperature Derating Graph  
Output power  
See below products program  
0.6  
6
W
Positive voltage accuracy  
Negative voltage accuracy  
Load regulation  
Refer to recommended circuit  
Refer to recommended circuit  
From 10% to 100% load  
20MHz Bandwidth  
±1  
±3  
±3  
±5  
%
%
±0.5  
20  
±1*  
50  
%
Ripple **  
mVp-p  
%/  
%
Temperature drift (Vout)  
Line regulation  
Refer to recommended circuit  
Input voltage from low to high  
20MHz Bandwidth  
±0.02  
±0.2  
50  
±0.5  
100  
Noise**  
mVp-p  
KHz  
Switching frequency  
100% load, input voltage range  
300  
RECOMMENDED CIRCUIT  
*
Dual output models unbalanced load: ±5%.  
Output Graph  
** Test ripple and noise by “parallel cable” method. See detailed operation instructions at Testing of Power Converter section,  
application notes.  
APPLICATION NOTE  
Requirement on output load  
In order to ensure the product operate efficiently and reliably,in addition to a  
max load(namely full load), a minimum load is specified for this kind of  
DC/DC converter.Make sure the specified range of input voltage is not  
exceeded,the minimum output load no less than 10% load.If the actual  
load is less than the specified minimum load, the output ripple may increase  
sharply while its efficiency and reliability will reduce greatly.If the actual  
output power is very small,please add an appropriate resistor as extra  
loading,or contact our company for other lower output power products.  
Recommended Circuit  
All the WRA_YD-6W&WRB_YD-6W Series have been tested according to  
the following recommended testing circuit before leaving factory.This series  
should be tested under load(See figure 1).  
If you want to further decrease the input/output ripple,you can increase  
capacitance properly or choose capacitors with low ESR. However, the  
capacitance of the output filter capacitor must be proper. If the capacitance  
is too big, a startup problem might arise. For every channel of output,  
provided the safe and reliable operation is ensured, the greatest capacitance  
of its filter capacitor sees (Table 1).  
General:  
Cin: 5V12V 100μF  
24V48V 100μF-47μF  
Cout: 10μF/100mA  
Output External Capacitor Table(Table 1)  
Single Vout  
Cout  
(μF)  
2200  
1000  
470  
Dual Vout Cout  
Input current  
(VDC)  
3.3  
5
(VDC)  
±5  
(μF)  
680  
330  
220  
--  
While using unstable power source,please ensure the output voltage and  
ripple voltage do not exceed indexes of the converter. Input current of  
power supply should afford the startup current of this kind of DC/DC module  
(See figure 2).  
±12  
±15  
--  
12  
General:Ip≤1.4*Iin-max  
15  
330  
No parallel connection or plug and play  
http://www.microdc.cn Technical Enquiries-Email:tech@microdc.cn Tel:0086-20-86000646  
page 2/3  

与WRB1215YD-6W相关器件

型号 品牌 描述 获取价格 数据表
WRB1215YD-8W MICRODC 8W,WIDE INPUT, ISOLATED & REGULATEDDUAL/SINGLEOUTPUTDC-DCCONVERTER

获取价格

WRB1215YDK-3W MICRODC 3W,Wide Input,ISOLATED®ULATED SINGLE OUTPUT DC/DC Converters

获取价格

WRB1215YDV-3W MICRODC 3W,WIDE INPUT, ISOLATED & REGULATED DUAL/SINGLE OUTPUT DIP DC-DC CONVERTER

获取价格

WRB1215YES-1W MICRODC Wide Input,Isolated&Regulated Single Output SIP12 DC-DC Converter

获取价格

WRB1215YES-2W MICRODC Wide Input,Isolated&Regulated Single Output SIP12 DC-DC Converter

获取价格

WRB1215YMD-10W MICRODC 2:1 WIDE INPUT,ISOLATED®ULATED Single Output DC/DC Converter

获取价格