The product information in this catalog is for reference only. Please request the Engineering Drawing for the most current and accurate design information.
All non-RoHS products have been discontinued, or will be discontinued soon. Please check the products status on the Hirose website RoHS search at www.hirose-connectors.com, or contact your Hirose sales representative.
ꢀ Product Specifications
Nominal characteristic impedance
Voltage rating
50 ohms
60 V AC (rms)
DC to 6 GHz
Operating temperature range
Operating humidity
-40˚C to +90˚C
90% max.
Ratings
Frequency range
Item
Specification
Conditions
1. Contact resistance
Center: 20 m ohms max.
Outside: 10 m ohms max.
500 M ohms min.
10 mA max.
2. Insulation resistance
3. Withstanding voltage
4. V.S.W.R.*
100 V DC
No flashover or insulation breakdown.
Part No.
200 V AC / 1 minute
Up to 3GHz
1.3 Max
3 to 6GHz
U.FL-LP-040 dia.0.81mm Coaxial Cable Assembly
1.35 Max
1.3 Max
1.4 Max
1.5 Max
1.3 Max
1.4 Max
U.FL-LP(V)-040 dia.0.81mm Coaxial Cable Assembly
U.FL-LP-068 dia.1.13mm Coaxial Cable Assembly
U.FL-LP-066 dia.1.32mm Coaxial Cable Assembly
U.FL-LP-062 dia.1mm Coaxial Cable Assembly
U.FL-LP-088 dia.1.37mm Coaxial Cable Assembly
1.3 Max
1.3 Max
1.3 Max
1.3 Max
1.3 Max
5. Center contact holding force 0.15 N min.
Measured with a Ø 0.475 pin gauge
6. Durability
Contact resistance
(mating/un-mating,
with corresponding plug)
7. Vibration
Center: 25 m ohms max.
Outside: 15 m ohms max.
30 cycles
Frequency: 10 to 100 Hz, single amplitude of 1.5mm, acceleration
of 59m/s2, for 5 cycles in the direction of each of the 3 axis.
Acceleration of 735 m/s2, 11ms duration, sine half-wave
waveform, 6 cycles in each of 3 axes.
No electrical discontinuity of 1µs min.
No damage, cracks or parts dislocation.
8. Shock
9. Humidity
No damage, cracks or parts dislocation.
(Steady state)
Insulation resistance 100 M ohms min.(when humidity high) 96 hours at temperature of 40ç and humidity of 95%.
Insulation resistance 500 M ohms min.(when dry)
10. Temperature cycle
No damage, cracks or parts dislocation.
Contact resistance:25 m ohms max. (Center)
15 m ohms max. (Outside)
Temperature:-40˚C +5 to +35˚C +90˚C +5 to +35˚C
/
/
/
Time:
30
5 max.
30
/
5 max.(Minutes)
/
/
5 cycles
11. Salt spray test
No excessive corrosion
5% salt water solution, 48 hours
*V.S.W.R. Measurement System
The above V.S.W.R. standard values were measured using the measurement connection shown below.
Note 1: Cable type connectors were measured with SMA conversion adapters
attached to both ends of the harness product of a suitable 100cm cable.
Note 2: Board type connectors were mounted to a 50Ω glass epoxy board and
measurements were conducted with SMA conversion adapters attached.
ꢀMaterial/Finishes
Part
Material
Phosphor bronze
Brass
Finish
Remarks
—————
—————
—————
UL94V-0
Shell
Silver plated
Gold plated
Gold plated
Color: Black
Color: Beige
Male center contact
Female center contact
Phosphor bronze
Plug
Receptacle
PBT
LCP
Insulator
UL94V-0
2