TPS629210
SLVSGE0A – AUGUST 2021 – REVISED SEPTEMBER 2021
TPS629210 3-V to 17-V, 1-A Low IQ Buck Converter in SOT583 Package
1 Features
3 Description
•
•
•
High-efficiency DCS-Control™ topology
Low quiescent current: 4 µA typical
Dynamically selectable forced PWM or auto power
save mode operations
2.5-MHz or 1.0-MHz selectable switching
frequencies
The TPS6292xx family of devices are highly efficient,
small, and highly flexible synchronous step-down DC-
DC converters that are easy to use. A wide 3-V
to 17-V input voltage range supports a wide variety
of systems powered from either 12-V, 5-V, or 3.3-V
supply rails, or single-cell or multi-cell Li-Ion batteries.
The TPS629210 can be configured to run at either
2.5-MHz or 1-MHz in a Forced PWM mode or a
variable frequency mode. In Auto PFM mode, the
device automatically transitions to Power Save mode
at light loads to maintain high efficiency. The low
4-µA typical quiescent current also provides high
efficiency down to the smallest loads. TI's AEE mode
holds a high conversion efficiency through the whole
operation range without the need of using different
inductors by automatically adjusting the switching
frequency based on input and output voltages. In
addition to selecting the switching frequency behavior,
the MODE/Smart-CONFIG input pin can also be used
to select between different combinations of external/
internal feedback dividers and enabling/disabling the
output voltage discharge capability. In the internal
feedback configuration, a resistor between the FB/
VSET pin and GND can be used to select between
18 different output voltage options (see Table 8-2).
•
•
•
•
•
Output current up to 1 A
RDSON: 300-mΩ high-side, 100-mΩ low-side
Output voltage accuracy of ± 1% over temperature
Configurable output voltage options:
– VFB external divider: 0.6 V to 5.5 V
– VSET internal divider:
•
18 options between 0.4 V and 5.5 V
•
•
•
•
•
•
•
No external bootstrap capacitor required
Output overcurrent and overtemperature protection
100% duty cycle mode
Precise enable input
Power-good output
Selectable active output discharge
Pin-to-pin compatible with TPS629206 and
TPS629203 devices
•
0.5-mm pitch 8-pin SOT583 package
2 Applications
•
•
•
•
•
•
•
•
VIN
Appliances
Building automation
Digital still camera
Electronic point of sale (ePOS)
Grid infrastructure
Modems
Device Information
PART NUMBER
PACKAGE(1)
BODY SIZE (NOM)
TPS629210
SOT583 (8)
1.60 mm x 2.10 mm
(1) For all available packages, see the orderable addendum at
the end of the data sheet.
PC and notebooks
Personal electronics
VOUT
0.4V œ 5.5V
2.2 µH
3V œ 17V
VIN
EN
SW
22 ꢀF
4.7 ꢀF
VOS
FB/
VSET
MODE/
S-CONF
PG
GND
Efficiency vs Output Current
(12 V to 3.3 V at 2.5 MHz)
Simplified Schematic
An IMPORTANT NOTICE at the end of this data sheet addresses availability, warranty, changes, use in safety-critical applications,
intellectual property matters and other important disclaimers. ADVANCE INFORMATION for preproduction products; subject to change
without notice.