®
TOP221-227
®
TOPSwitch-II Family
Three-terminal Off-line PWM Switch
Product Highlights
AC
IN
• Lowest cost, lowest component count switcher solution
• Cost competitive with linears above 5W
• Very low AC/DC losses – up to 90% efficiency
• Built-in Auto-restart and Current limiting
• Latching Thermal shutdown for system level protection
• Implements Flyback, Forward, Boost or Buck topology
• Works with primary or opto feedback
• Stable in discontinuous or continuous conduction mode
• Source connected tab for low EMI
D
S
CONTROL
C
TOPSwitch
• Circuit simplicity and Design Tools reduce time to market
PI-1951-091996
Description
Figure 1. Typical Flyback Application.
The second generation TOPSwitch-II family is more cost
effective and provides several enhancements over the first
generationTOPSwitchfamily. TheTOPSwitch-IIfamilyextends
the power range from 100W to 150W for 100/115/230 VAC
input and from 50W to 90W for 85-265 VAC universal input.
This brings TOPSwitch technology advantages to many new
applications, i.e. TV, Monitor, Audio amplifiers, etc. Many
significant circuit enhancements that reduce the sensitivity to
board layout and line transients now make the design even
easier. The standard 8L PDIP package option reduces cost in
lower power, high efficiency applications. The internal lead
frame of this package uses six of its pins to transfer heat from
the chip directly to the board, eliminating the cost of a heat sink.
TOPSwitch incorporates all functions necessary for a switched
modecontrolsystemintoathreeterminalmonolithicIC:power
MOSFET, PWM controller, high voltage start up circuit, loop
compensation and fault protection circuitry.
OUTPUT POWER TABLE
TO-220 (Y) Package1
8L PDIP (P) or 8L SMD (G) Package2
3
Single Voltage Input3
Wide Range Input
.
Single Voltage Input
Wide Range Input
85 to 265 VAC
PART
ORDER
NUMBER
PART
ORDER
NUMBER
100/115/230 VAC 15%
100/115/230 VAC 15%
85 to 265 VAC
4,6
4,6
5,6
5,6
PMAX
PMAX
PMAX
PMAX
TOP221Y
TOP222Y
TOP223Y
TOP224Y
TOP225Y
TOP226Y
TOP227Y
7 W
TOP221P or TOP221G
TOP222P or TOP222G
TOP223P or TOP223G
TOP224P or TOP224G
9 W
6 W
12 W
15 W
25 W
30 W
10 W
15 W
20 W
25 W
15 W
30 W
45 W
60 W
75 W
90 W
50 W
75 W
100 W
125 W
150 W
Notes: 1. Package outline: TO-220/3 2. Package Outline: DIP-8 or SMD-8 3. 100/115 VAC with doubler input 4. Assumes appropriate
heat sinking to keep the maximum TOPSwitch junction temperature below 100 °C. 5. Soldered to 1 sq. in.( 6.45 cm2), 2 oz. copper clad
(610 gm/m2) 6. P
is the maximum practical continuous power output level for conditions shown. The continuous power capability
in a given applicatMioAnX depends on thermal environment, transformer design, efficiency required, minimum specified input voltage, input
storage capacitance, etc. 7. Refer to key application considerations section when using TOPSwitch-II in an existing TOPSwitch design.
July 2001