5秒后页面跳转
TL052CPSRG4 PDF预览

TL052CPSRG4

更新时间: 2024-09-23 20:35:15
品牌 Logo 应用领域
德州仪器 - TI 放大器光电二极管
页数 文件大小 规格书
68页 1923K
描述
DUAL OP-AMP, 4500uV OFFSET-MAX, 3MHz BAND WIDTH, PDSO8, GREEN, PLASTIC, SOP-8

TL052CPSRG4 技术参数

是否无铅:不含铅是否Rohs认证:符合
生命周期:Obsolete零件包装代码:SOIC
包装说明:GREEN, PLASTIC, SOP-8针数:8
Reach Compliance Code:unknownECCN代码:EAR99
HTS代码:8542.33.00.01风险等级:5.45
Is Samacsys:N放大器类型:OPERATIONAL AMPLIFIER
架构:VOLTAGE-FEEDBACK最大平均偏置电流 (IIB):0.0002 µA
25C 时的最大偏置电流 (IIB):0.0002 µA标称共模抑制比:85 dB
频率补偿:YES最大输入失调电流 (IIO):0.001 µA
最大输入失调电压:4500 µVJESD-30 代码:R-PDSO-G8
JESD-609代码:e4长度:6.2 mm
低-偏置:YES低-失调:NO
湿度敏感等级:1负供电电压上限:-18 V
标称负供电电压 (Vsup):-5 V功能数量:2
端子数量:8最高工作温度:70 °C
最低工作温度:封装主体材料:PLASTIC/EPOXY
封装代码:SOP封装等效代码:SOP8,.3
封装形状:RECTANGULAR封装形式:SMALL OUTLINE
包装方法:TAPE AND REEL峰值回流温度(摄氏度):260
电源:+-5/+-15 V认证状态:Not Qualified
座面最大高度:2 mm最小摆率:8 V/us
标称压摆率:17.8 V/us子类别:Operational Amplifier
最大压摆率:6.4 mA供电电压上限:18 V
标称供电电压 (Vsup):5 V表面贴装:YES
技术:BIPOLAR温度等级:COMMERCIAL
端子面层:Nickel/Palladium/Gold (Ni/Pd/Au)端子形式:GULL WING
端子节距:1.27 mm端子位置:DUAL
处于峰值回流温度下的最长时间:NOT SPECIFIED标称均一增益带宽:3000 kHz
最小电压增益:20000宽度:5.3 mm
Base Number Matches:1

TL052CPSRG4 数据手册

 浏览型号TL052CPSRG4的Datasheet PDF文件第2页浏览型号TL052CPSRG4的Datasheet PDF文件第3页浏览型号TL052CPSRG4的Datasheet PDF文件第4页浏览型号TL052CPSRG4的Datasheet PDF文件第5页浏览型号TL052CPSRG4的Datasheet PDF文件第6页浏览型号TL052CPSRG4的Datasheet PDF文件第7页 
TL05x, TL05xA  
ENHANCED-JFET LOW-OFFSET  
OPERATIONAL AMPLIFIERS  
SLOS178A – FEBRUARY 1997 - REVISED FEBRUARY 2003  
Direct Upgrades to TL07x and TL08x BiFET  
Operational Amplifiers  
On-Chip Offset-Voltage Trimming for  
Improved DC Performance and Precision  
Grades Are Available (1.5 mV, TL051A)  
Faster Slew Rate (20 V/µs Typ) Without  
Increased Power Consumption  
TL051  
D OR P PACKAGE  
(TOP VIEW)  
TL052  
D, P, OR PS PACKAGE  
(TOP VIEW)  
TL054  
D, DB, N, OR NS PACKAGE  
(TOP VIEW)  
1OUT  
1IN–  
1IN+  
4OUT  
4IN–  
4IN+  
OFFSET N1  
IN–  
NC  
V
OUT  
1OUT  
1IN–  
1IN+  
V
1
2
3
4
5
6
7
14  
13  
12  
11  
10  
9
1
2
3
4
8
7
6
5
1
2
3
4
8
7
6
5
CC+  
2OUT  
2IN–  
2IN+  
CC+  
IN+  
V
V
V
OFFSET N2  
V
CC+  
CC–  
CC–  
CC–  
2IN+  
2IN–  
2OUT  
3IN+  
3IN–  
3OUT  
8
description/ordering information  
The TL05x series of JFET-input operational amplifiers offers improved dc and ac characteristics over the TL07x  
and TL08x families of BiFET operational amplifiers. On-chip Zener trimming of offset voltage yields precision  
grades as low as 1.5 mV (TL051A) for greater accuracy in dc-coupled applications. Texas Instruments improved  
BiFET process and optimized designs also yield improved bandwidth and slew rate without increased power  
consumption. The TL05x devices are pin-compatible with the TL07x and TL08x and can be used to upgrade  
existing circuits or for optimal performance in new designs.  
BiFET operational amplifiers offer the inherently higher input impedance of the JFET-input transistors, without  
sacrificing the output drive associated with bipolar amplifiers. This makes them better suited for interfacing with  
high-impedance sensors or very low-level ac signals. They also feature inherently better ac response than  
bipolar or CMOS devices having comparable power consumption.  
The TL05x family was designed to offer higher precision and better ac response than the TL08x, with the low  
noise floor of the TL07x. Designers requiring significantly faster ac response or ensured lower noise should  
consider the Excalibur TLE208x and TLE207x families of BiFET operational amplifiers.  
Because BiFET operational amplifiers are designed for use with dual power supplies, care must be taken to  
observe common-mode input voltage limits and output swing when operating from a single supply. DC biasing  
of the input signal is required, and loads should be terminated to a virtual-ground node at mid-supply. Texas  
Instruments TLE2426 integrated virtual ground generator is useful when operating BiFET amplifiers from single  
supplies.  
The TL05x are fully specified at ±15 V and ±5 V. For operation in low-voltage and/or single-supply systems,  
Texas Instruments LinCMOS families of operational amplifiers (TLC-prefix) are recommended. When moving  
from BiFET to CMOS amplifiers, particular attention should be paid to the slew rate and bandwidth  
requirements, and also the output loading.  
Please be aware that an important notice concerning availability, standard warranty, and use in critical applications of  
Texas Instruments semiconductor products and disclaimers thereto appears at the end of this data sheet.  
Copyright 2003, Texas Instruments Incorporated  
PRODUCTION DATA information is current as of publication date.  
Products conform to specifications per the terms of Texas Instruments  
standard warranty. Production processing does not necessarily include  
testing of all parameters.  
1
POST OFFICE BOX 655303 DALLAS, TEXAS 75265  

与TL052CPSRG4相关器件

型号 品牌 获取价格 描述 数据表
TL052I TI

获取价格

ENHANCED-JFET LOW-OFFSET OPERATIONAL AMPLIFIERS
TL052ID STMICROELECTRONICS

获取价格

ENHANCED-JFET LOW-OFFSET OPERATIONAL AMPLIFIERS
TL052ID TI

获取价格

ENHANCED-JFET LOW-OFFSET OPERATIONAL AMPLIFIERS
TL052ID ROCHESTER

获取价格

DUAL OP-AMP, 5300uV OFFSET-MAX, 3MHz BAND WIDTH, PDSO8, GREEN, PLASTIC, MS-012AA, SOIC-8
TL052IDE4 TI

获取价格

ENHANCED-JFET LOW-OFFSET OPERATIONAL AMPLIFIERS
TL052IDE4 STMICROELECTRONICS

获取价格

ENHANCED-JFET LOW-OFFSET OPERATIONAL AMPLIFIERS
TL052IDG4 TI

获取价格

ENHANCED-JFET LOW-OFFSET OPERATIONAL AMPLIFIERS
TL052IDG4 STMICROELECTRONICS

获取价格

ENHANCED-JFET LOW-OFFSET OPERATIONAL AMPLIFIERS
TL052IDR TI

获取价格

ENHANCED-JFET LOW-OFFSET OPERATIONAL AMPLIFIERS
TL052IDR STMICROELECTRONICS

获取价格

ENHANCED-JFET LOW-OFFSET OPERATIONAL AMPLIFIERS