5秒后页面跳转
TCA9416DDFR PDF预览

TCA9416DDFR

更新时间: 2024-09-25 02:52:23
品牌 Logo 应用领域
德州仪器 - TI /
页数 文件大小 规格书
30页 1876K
描述
TCA9416 Ultra-Low-Voltage I2C Translator with Rise Time Accelerators

TCA9416DDFR 数据手册

 浏览型号TCA9416DDFR的Datasheet PDF文件第2页浏览型号TCA9416DDFR的Datasheet PDF文件第3页浏览型号TCA9416DDFR的Datasheet PDF文件第4页浏览型号TCA9416DDFR的Datasheet PDF文件第5页浏览型号TCA9416DDFR的Datasheet PDF文件第6页浏览型号TCA9416DDFR的Datasheet PDF文件第7页 
TCA9416  
SCPS238A – FEBRUARY 2021 – REVISED AUGUST 2021  
TCA9416 Ultra-Low-Voltage I2C Translator with Rise Time Accelerators  
1 Features  
3 Description  
2-bit bidirectional translator for SDA and SCL lines  
in I2C applications  
Provides bidirectional voltage translation with no  
direction pin  
High-impedance output SCL_A, SDA_A, SCL_B,  
SDA_B pins when OE = 0 V or VCC = 0 V  
Internal 10-kΩ pull-up resistor on all SDA and SCL  
pins are enabled based on respective VCC voltage  
1.08 V to 3.6 V on both A and B ports  
VCC Isolation feature: If either VCC input is at  
GND, both ports are in the high-impedance state  
(excluding pull-ups)  
The TCA9416 is a 2-bit bidirectional I2C and SMBus  
voltage-level translator with an output enable (OE)  
input and rising and falling edge accelerators. It is  
operational from 1.08 V to 3.6 V on both the A-  
side and B-side. This allows the device to interface  
between lower and higher logic signal levels at any of  
the typical 1.2-V, 1.8-V, 2.5-V, and 3.3-V supply rails.  
The OE input pin is referenced to VCCA, can be  
tied directly to VCCA, but it is also 3.6-V tolerant.  
The OE pin can also be controlled and set to a  
logic low to place all the SCL and SDA pins in a  
high-impedance state, which significantly reduces the  
quiescent current consumption.  
No power-supply sequencing required: either VCCA  
or VCCB can be ramped first  
Low Ioff of 2.5 µA when either VCCA or VCCB = 0 V  
OE input can be tied directly to VCCA or controlled  
by GPIO  
Latch-up performance exceeds 100 mA per JESD  
78, class II  
ESD Protection exceeds JESD 22  
– 2500-V Human-body model (A114-B)  
– 1500-V Charged-device model (C101)  
Under normal I2C and SMBus configurations, the  
TCA9416 is compatible with standard speeds where  
the frequency of SCL is 100 kHz (Standard-mode),  
400 kHz (Fast-mode), or 1 MHz (Fast-mode Plus).  
The TCA9416 features internal 10-kΩ pull-up resistors  
on SCL_A, SDA_A, SCL_B, and SDA_B. Additional  
external pull-up resistors can be added to the bus to  
reduce the total pull-up resistance and speed up rising  
edges.  
2 Applications  
Device Information  
Wearables  
Personal electronics  
Servers  
PART NUMBER  
TCA9416  
PACKAGE(1)  
BODY SIZE (NOM)  
1.35 mm × 0.80 mm  
2.9 mm × 1.6 mm  
X2SON (8)  
SOT-23-T (8)  
(1) For all available packages, see the orderable addendum at  
the end of the datasheet.  
spacer  
Typical Application Block Diagram for TCA9416  
An IMPORTANT NOTICE at the end of this data sheet addresses availability, warranty, changes, use in safety-critical applications,  
intellectual property matters and other important disclaimers. PRODUCTION DATA.  
 
 
 

与TCA9416DDFR相关器件

型号 品牌 获取价格 描述 数据表
TCA9416DTMR TI

获取价格

TCA9416 Ultra-Low-Voltage I2C Translator with Rise Time Accelerators
TCA9509 TI

获取价格

LEVEL-TRANSLATING I2C/SMBUS BUS REPEATER
TCA9509_13 TI

获取价格

LEVEL-TRANSLATING I2C/SMBUS BUS REPEATER
TCA9509DGKR TI

获取价格

LEVEL-TRANSLATING I2C/SMBUS BUS REPEATER
TCA9509MRVHR TI

获取价格

具有内部 1mA 拉电流的 2 位电平转换 400kHz I2C/SMBus 缓冲器/中继
TCA9509RVHR TI

获取价格

LEVEL-TRANSLATING I2C/SMBUS BUS REPEATER
TCA9511A TI

获取价格

2 位双向 2.3V 至 5.5V 热插拔 400kHz I2C/SMBus 缓冲器
TCA9511ADGKR TI

获取价格

2 位双向 2.3V 至 5.5V 热插拔 400kHz I2C/SMBus 缓冲器 |
TCA9517 TI

获取价格

LEVEL-TRANSLATING I2C BUS REPEATER
TCA9517A TI

获取价格

LEVEL-TRANSLATING I2C BUS REPEATER