5秒后页面跳转
捷配首页

Datasheet > SN65HVD101RTJ
SN65HVD101RTJ PDF预览

SN65HVD101RTJ

更新时间： 2024-02-21 06:51:08
品牌 Logo 应用领域
德州仪器 - TI /
页数 文件大小 规格书
4页 105K
描述
IO-LINK PHY for Device Nodes

阅读下载

中文翻译

获取价格

SN65HVD101RTJ 技术参数

是否无铅： 不含铅是否Rohs认证： 符合
生命周期：Active包装说明：HVQCCN,
Reach Compliance Code：compliantECCN代码：EAR99
HTS代码：8542.39.00.01Factory Lead Time：6 weeks
风险等级：1.33JESD-30 代码：R-PQCC-N20
JESD-609代码：e4长度：4 mm
湿度敏感等级：2功能数量：1
端子数量：20最高工作温度：105 °C
最低工作温度：-40 °C封装主体材料：PLASTIC/EPOXY
封装代码：HVQCCN封装形状：RECTANGULAR
封装形式：CHIP CARRIER, HEAT SINK/SLUG, VERY THIN PROFILE峰值回流温度（摄氏度）：260
座面最大高度：1 mm最大压摆率：3 mA
标称供电电压：24 V表面贴装：YES
电信集成电路类型：SUPPORT CIRCUIT温度等级：INDUSTRIAL
端子面层：Nickel/Palladium/Gold (Ni/Pd/Au)端子形式：NO LEAD
端子节距：0.5 mm端子位置：QUAD
处于峰值回流温度下的最长时间：NOT SPECIFIED宽度：3.5 mm
Base Number Matches：1

SN65HVD101RTJ 数据手册

 浏览型号SN65HVD101RTJ的Datasheet PDF文件第2页浏览型号SN65HVD101RTJ的Datasheet PDF文件第3页浏览型号SN65HVD101RTJ的Datasheet PDF文件第4页 
SN65HVD100  
SN65HVD101  
www.ti.com  
SLLSE84 –MAY 2011  
IO-LINK PHY for Device Nodes  
Check for Samples: SN65HVD100 , SN65HVD101  
•
•
•
•
•
•
Overtemperature Protection  
1
FEATURES  
Reverse Polarity Protection  
Configurable Current Limits  
9-V to 36-V Supply Range  
Tolerant to 50-V Peak Line Voltage  
3.3-V/5-V Configurable Integrated LDO  
(SN65HVD101 ONLY)  
•
•
Suitable for IO-Link Device Nodes  
Configurable CQ Output: Push-Pull, High-Side,  
or Low-Side for SIO Mode  
Remote Wake-Up Indicator  
Current Limit Indicator  
Power-Good Indicator  
•
•
•
•
20-pin QFN Package, 4 mm × 4 mm  
DESCRIPTION  
The SN65HVD100 and ‘HVD101 IO-LINK PHYs implement the IO-LINK interface for industrial point-to-point  
communication. When the device is connected to an IO-Link master through a 3-wire interface, the master can  
initiate communication and exchange data with the remote node while the SN65HVD10X acts as a complete  
physical layer for the communication.  
The IO-LINK driver output (CQ) can be used in push-pull, high-side, or low-side configurations using the EN and  
TX input pins. The PHY receiver converts the 24-V IO-LINK signal on the CQ pin to standard logic levels on the  
RX pin. A simple parallel interface is used to receive and transmit data and status information between the PHY  
and the local controller.  
The SN65HVD10X implements protection features for overcurrent, overvoltage and overtemperature conditions.  
The IO-Link driver current limit can be set using an external resistor. If a short-circuit current fault occurs, the  
driver outputs are internally limited, and the PHY generates an error signal (SC). These devices also implement  
an overtemperature shutdown feature that protects the device from high-temperature faults.  
The SN65HVD100 operates from a single external 3.3-V or 5-V local supply. The SN65HVD101 integrates a  
linear regulator that generates either 3.3 V or 5 V from the IO-Link L+ voltage for supplying power to the PHY as  
well as a local controller and additional circuits.  
SN65HVD10X is available in a 20-pin RTJ package (4 mm × 4m m QFN) compatible with the ELMOS E981.10  
and in the 20-pin RGB package (4 mm × 3,5 mm QFN) for space-constrained applications.  
VCC VCC VCC  
OUT  
IN SET  
L+  
SUPPLY VOLTAGE  
CONTROL  
PWR_OK  
RX  
CQ  
TX  
EN  
Voltage  
Timers  
Voltage  
Detectors  
L-  
Over Current  
Timers  
Control  
Logic  
Over Current  
Detectors  
WAKE  
TEMPERATURE  
SENSE  
CUR_OK  
TEMP_OK  
GND  
ILIM_ADJ  
L-  
1
Please be aware that an important notice concerning availability, standard warranty, and use in critical applications of Texas  
Instruments semiconductor products and disclaimers thereto appears at the end of this data sheet.  
PRODUCT PREVIEW information concerns products in the  
formative or design phase of development. Characteristic data and  
other specifications are design goals. Texas Instruments reserves  
the right to change or discontinue these products without notice.  
Copyright © 2011, Texas Instruments Incorporated  
1234

中文翻译

下载PDF

与SN65HVD101RTJ相关器件

型号 品牌 获取价格 描述 数据表
SN65HVD102 TI

获取价格

 		Check for Samples: SN65HVD101, SN65HVD102
SN65HVD102RGBR TI

获取价格

 		用于器件节点的 IO-Link PHY | RGB | 20 | -40 to 105
SN65HVD102RGBT TI

获取价格

 		用于器件节点的 IO-Link PHY | RGB | 20 | -40 to 105
SN65HVD1040 TI

获取价格

 		LOW-POWER CAN TRANSCEIVER WITH BUS WAKE-UP
SN65HVD1040A-Q1 TI

获取价格

 		EMC-OPTIMIZED HIGH SPEED CAN TRANSCEIVER
SN65HVD1040A-Q1_10 TI

获取价格

 		EMC-OPTIMIZED HIGH SPEED CAN TRANSCEIVER
SN65HVD1040A-Q1_101 TI

获取价格

 		EMC-OPTIMIZED HIGH SPEED CAN TRANSCEIVER
SN65HVD1040AQDRQ1 TI

获取价格

 		EMC-OPTIMIZED HIGH SPEED CAN TRANSCEIVER
SN65HVD1040D TI

获取价格

 		LOW-POWER CAN TRANSCEIVER WITH BUS WAKE-UP
SN65HVD1040DG4 TI

获取价格

 		LOW-POWER CAN TRANSCEIVER WITH BUS WAKE-UP

与SN65HVD101RTJ相关文章

您还可以找


热门产品
PCB打样/小批量
铝基板
BOM智能配单
PCBA制造
钣金
精密CNC
模具注塑
薄膜开关
精选活动
PCBA打样特惠
四六层板品质升级
铝基板品质升级
一体化电子制造
DFM下载
服务支持
企业认证
产品展示
工厂展示
工艺能力
积分商城
关于捷配
捷配简介
企业文化
公司动态
人才招聘
联系我们
帮助中心
下单流程
付款流程
开票流程
常见问题
全球PCB制造服务专线 400-613-0088

工作时间：9:00-21:00

CEO邮箱：ceo@jiepei.com

投诉邮箱：tousu@jiepei.com

捷配网-微信公众号 微信公众号
捷配网-微信公众号 抖音公众号
资质认证：
合作快递：
支付方式：
Copyright © 2024 Jiepei.com Inc. All Rights Reserved. 版权所有:杭州捷配信息科技有限公司 浙公网安备 33010502006866号 浙ICP备10014259号-119 营业执照ICP证