SG1543/SG2543/SG3543
Power Supply Output Supervisory Circuit
Features
Over-Voltage, Under-Voltage, and
Description
.
This monolithic integrated circuit contains all the functions necessary to
monitor and control the output of a sophisticated power supply system.
Over-voltage (O.V.) sensing with provision to trigger an external SCR
“crowbar” shutdown; an under-voltage (U.V.) circuit which can be used to
monitor either the output or to sample the input line voltage; and a third
op amp/comparator usable for current sensing (C.L.) are all included in
this IC, together with an independent, accurate reference generator.
Current Sensing Circuits all included.
.
.
Reference Voltage Trimmed to 1%
Accuracy.
SCR "Crowbar" Drive of 300mA.
. Programmable Time Delays.
Both over and under-voltage sensing circuits can be externally
programmed for minimum time duration of fault before triggering. All
functions contain open collector outputs which can be used
independently or wire-ORed together; and although the SCR trigger is
directly connected only to the over-voltage sensing circuit, it may be
optionally activated by any of the other outputs, or from an external
signal. The O.V. circuit also includes an optional latch and external reset
capability.
Open-Collector Outputs and Remote
Activation Capability.
.
Total Standby Current less than 10mA.
.
High Reliability
Features
The current sense circuit may be used with external compensation as a
linear amplifier or as a high gain comparator. Although nominally set for
zero input offset, a fixed threshold may be added with an external
resistor. Instead of current limiting, this circuit may also be used as an
additional voltage monitor.
Available to MIL-STD-883, ¶ 1.2.1
.
. MSC-AMS level “S” Processing
Available
. Available to DSCC
– Standard Microcircuit Drawing (SMD)
The reference generator circuit is internally trimmed to eliminate the need
for external potentiometers and the entire circuit may be powered directly
from either the output being monitored or from a separate bias voltage.
Block Diagram
February 2015 Rev. 1.2
www.microsemi.com
1
© 2015 Microsemi Corporation