SE1482
2A 27V Synchronous Buck Converter
Functional Block Diagram
Ordering Information
Part Number
Marking Information
Package
SOP8
Remarks
YYWW means Production batch
XX=HF: Halogen Free.
SE1482
SE1482-HF
YYWW-HF
PSOP8
Pin Descriptions
Pin Num Pin
Descriptions
Bootstrap. This pin acts as the positive rail for the high-side switch’s gate driver.
Connect a 0.01uF capacitor between BS and SW.
1
2
BS
Input Supply. Bypass this pin to GND with a low ESR capacitor. See Input Capacitor in
the Application Information section.
Vin
3
4
SW
Switch Output. Connect this pin to the switching end of the inductor.
GND Ground.
Feedback Input. The voltage at this pin is regulated to 0.925V. Connect to the resistor
divider between output and ground to set output voltage.
5
6
FB
COMP Compensation Pin. See Stability Compensation in the Application Information section.
Enable Input. When higher than 2.7V, this pin turns the IC on. When lower than 1.1V,
7
EN
this pin turns the IC off. Output voltage is discharged when the IC is off. This pin should
not be left open. Recommend to put a 100KΩ pull up resistor to Vin for start up.
Soft-Start Control Input. SS controls the soft-start period. Connect a capacitor from SS
to GND to set the soft-start period. A 0.1uF capacitor sets the soft-start period to 15ms.
To disable the soft-start feature, leave SS unconnected.
8
SS
Rev1.0
Preliminary and all contents are subject to change without prior notice.
© Seaward Electronics, Inc., • www.seawardinc.com.cn • Page 2
9/4/2012