SDX Series
Low cost compensated pressure sensors in DIP package
FEATURES
GENERAL DESCRIPTION
·
·
·
0...1 to 0...100 psi
The SDX series sensors will provide
a very cost effective solution for
pressure applications that require
small size plus performance. These
internally calibrated and temperature
compensated sensors give an accu-
rate and stable output over a 0 to 50°C
temperature range. This series is
intended for use with non-corrosive,
non-ionic working fluids such as air
and dry gases.
Low cost DIP package
Temperature
compensation
·
·
·
·
Calibrated zero and span
Small size
Devices are available to measure
absolute, differential and gage
pressures from 1 psi (SDX01) up to
100 psi (SDX100). The absolute (A)
devices have an internal vacuum
reference and an output voltage
proportional to absolute pressure.
Low noise
Scale:
1 cm
½ inch
High impedance for
low power applications
also provides convenient mounting
and pressure ports for ease of use
with standard plastic tubing for
pressure connection.
The output of the bridge is ratiometric
to the supply voltage and operation
from any D.C. supply voltage up to +20
V is acceptable.
APPLICATIONS
·
·
·
·
Medical equipment
All SDX devices are calibrated for span
to within 3.5 % and provide an offset
(zero pressure output) of ±1 mV max.
These parts were designed for low
cost applications where the user can
typically provide fine-adjustment of
zero and span in external circuitry. For
higher accuracies, refer to the SDX-A
series datasheet.
Computer peripherals
Pneumatic controls
HVAC
The SDX devices feature an integrated
circuit sensor element and laser
trimmed thick film ceramic housed in
a compact solvent resistant case. This
package provides excellent corrosion
resistance and isolation to external
package stresses. The DIP package
EQUIVALENT CIRCUIT
ELECTRICAL CONNECTION
TOP VIEWS
Pin 1 identified by
chamfered corner
Pin 1 identified by
chamfered corner
Vs
out -
GND
out +
out +
1
1
1
out +
P2
P1
P1
+Vs
GND
out -
+Vs
+Vs
GND
out -
P2
4
4
4
Vent hole
SDX...G2
SDX...A2
SDX...D4
+
-
Note: The polarity identicated is
1
out -
GND
out +
for pressure applied to
P1
+Vs
4
SDX...G2: P2 (backward gage)
SDX...A2: P1 (forward gage)
SDX...D4: P2 (backward gage)
SDX...A4: P1 (forward gage)
SDX...A4
June 2008 / 062
1/4
www.sensortechnics.com