5秒后页面跳转
RTQ2533W PDF预览

RTQ2533W

更新时间: 2024-01-16 19:32:35
品牌 Logo 应用领域
立锜 - RICHTEK /
页数 文件大小 规格书
19页 505K
描述
暂无描述

RTQ2533W 技术参数

Status:ActiveVin (min) (V):1.1
Vin (max) (V):6.5Vout (min) (V):0.8
Vout (max) (V):5.5Output Adj. Method:Fixed;Resistor
Accuracy (+/- %):1Iout (max) (mA):3000
Iq (typ) (uA):4300Current Limit (typ) (mA):
Vdropout @ rated current (typ) (mV):110 @ 3ACout (min) (uF):
Cout Type:CeramicBias Rail:
Charge Pump:Features:Enable Input;Extra Low Noise;High PSRR;OCP;Power Good
Package Type:VQFN3.5x3.5-20

RTQ2533W 数据手册

 浏览型号RTQ2533W的Datasheet PDF文件第1页浏览型号RTQ2533W的Datasheet PDF文件第2页浏览型号RTQ2533W的Datasheet PDF文件第4页浏览型号RTQ2533W的Datasheet PDF文件第5页浏览型号RTQ2533W的Datasheet PDF文件第6页浏览型号RTQ2533W的Datasheet PDF文件第7页 
RTQ2533W  
Functional Block Diagram  
VOUT  
VIN  
Charge  
Pump  
Active  
Discharge  
Current  
Limit  
Gate  
Driver  
Thermal  
Protection  
PGOOD  
0.72V  
UVLO  
+
-
Enable  
Control  
Logic  
UVLO  
-
EN  
SNS  
FB  
Bandgap  
Reference  
2R  
32R 16R  
8R  
4R  
2R  
1R  
INR/SS  
NR/SS GND  
50mV 100mV 200mV 400mV 800mV 1.6V  
Operation  
The RTQ2533W operates with single supply input ranging  
from 1.1V to 6.5V and capable to deliver up to 3A current  
to the output. The device features high PSRR and low  
noise provides a clean supply to the application.  
If not used, connect EN to the largest capacitance on the  
input as close as possible to prevent voltage droops on  
the VIN line from triggering the enable circuit.  
VOUT Programming Pins  
A low-noise reference and error amplifier are included to  
reduce device noise. TheNR/SS capacitor filters the noise  
from the reference and feed-forward capacitor filters the  
noise from the error amplifier. The high power-supply  
rejection ratio (PSRR) of the RTQ2533W minimizes the  
coupling of input supply noise to the output.  
The built-in matched feedback resistor network of the  
RTQ2533W can set the output voltage. The output voltage  
can be programmed from 0.8V to 3.95V in 50mV steps  
when tying these programming pins (Pins 5 to 11) to  
ground. Tying any of the VOUT programming pins to SNS  
can lower the value of the upper resistor divider. Hence  
the VOUT programming resolution is increased.  
Enable and Shutdown  
The RTQ2533W provides an EN pin, as an external chip  
enable control, to enable or disable the device. VEN below  
0.5 V turns the regulator off and enters the shutdown mode,  
while VEN above 1.1V turns the regulator on. When the  
regulator is shutdown, the ground current is reduced to a  
maximum of 25μA. The enable circuitry has hysteresis  
(typically 50mV) for use with relatively slowly ramping  
analog signals.  
Programmable Soft-Start  
The noise-reduction capacitor (CNR/SS) accomplishes the  
dual purpose of both noise-reduction and programming  
the soft-start ramp time during turn-on. When EN and  
UVLO exceed the respective threshold voltage, the  
RTQ2533W activates a quick-start circuit to charge the  
noise reduction capacitor (CNR/SS) and then the output  
voltage ramps up.  
Copyright 2019 Richtek Technology Corporation. All rights reserved.  
©
is a registered trademark of Richtek Technology Corporation.  
DSQ2533W-00 April 2019  
www.richtek.com  
3

与RTQ2533W相关器件

型号 品牌 获取价格 描述 数据表
RTQ2536-QA RICHTEK

获取价格

暂无描述
RTQ2537 RICHTEK

获取价格

4A, 6.5V, Ultra Low Noise, Ultra Low Dropout Linear Regulator
RTQ2538H RICHTEK

获取价格

2A, 6.5V, Ultra-Low Noise, Ultra-Low Dropout Linear Regulator
RTQ2539A RICHTEK

获取价格

3A, 6.5V, Ultra-Low Noise, Ultra-Low Dropout Linear Regulator
RTQ2539C RICHTEK

获取价格

3A, 6.5V, Ultra-Low Noise, Ultra-Low Dropout Linear Regulator
RTQ2540H RICHTEK

获取价格

4A, 6.5V, Ultra-Low Noise, Ultra-Low Dropout Linear Regulator
RTQ2551A RICHTEK

获取价格

1A Ultra-Low Dropout Voltage LDO Regulators with Soft-Start
RTQ2551A-QA RICHTEK

获取价格

1A Ultra-Low Dropout Voltage LDO Regulators with Soft-Start
RTQ2569-QA RICHTEK

获取价格

36V, 2μA IQ, Peak 200mA, Low Dropout Voltage
RTQ-25V101MG10UQ-R2 TAIYO YUDEN

获取价格

FOR AUTOMOTIVE VERTICAL CHIP TYPE ALUMINUM ELECTROLYTIC CAPACITORS[RTQ]