MODEL: R7FN-TS4
EX-FACTORY SETTING
Remote I/O R7 Series
/SET: Preset according to the Ordering Information Sheet
(No. ESU-7808-TS4)
FLEX NETWORK I/O MODULE
(Thermocouple input, 4 points, isolated)
Functions & Features
RELATED PRODUCTS
• PC configurator software (model: R7CON)
The configurator software is downloadable at M-System’s
web site.
• 4 points thermocouple input module for FLEX NETWORK
• Input sensor can be selected with the front DIP switches
for all channels.
A dedicated cable is required to connect the module to the
PC. Please refer to the internet software download site or
the users manual for the PC configurator for applicable
cable types.
• Easy parameter setting of individual channels with M-
System's configurator software
FLEX NETWORK is registered trademark of Digital
Electronics Corporation in Japan.
• Screen editor software (model: GP-Pro EX)
Screen editor software GP-Pro EX (Ver.2.70 or higher) is
available.
115 (4.53)
For versions between 2.60 and 2.70, the driver must be
installed. The driver is downloadable at Digital Electronics
Corporation's web site. http://www.proface.co.jp/
53 (2.09)
GENERAL SPECIFICATIONS
Connection: M3 separable screw terminal (torque 0.5 N·m)
Solderless terminal: Refer to the drawing at the end of the
section.
54 (2.13)
mm (inch)
• Communication cable
MODEL: R7FN–TS4-R[1]
Recommended manufacture: Japan Solderless Terminal
MFG.Co.Ltd
ORDERING INFORMATION
• Code number: R7FN-TS4-R[1]
Specify a code from below for [1].
(e.g. R7FN-TS4-R/Q)
Applicable wire size: 0.2 to 0.5 mm
2
(AWG 26 to 22)
• Others
Recommended manufacture: Japan solderless terminal
MFG.Co.Ltd, Nichifu Co.,ltd
• Specify the specification for option code /Q
(e.g. /C01/SET)
Applicable wire size: 0.25 to 1.65 mm
2
(AWG 22 to 16)
Screw terminal: Nickel-plated steel
Housing material: Flame-resistant resin (gray)
Isolation: Input 0 to input 1 to input 2 to input 3 to FLEX
NETWORK to power to FG
I/O TYPE
TS4: Thermocouple input, 4 points
Zero adjustments: Configurable via R7CON
Span adjustments: Configurable via R7CON
Conversion rate: Configurable via R7CON
Thermocouple setting: Configurable via the front DIP switch
or R7CON
POWER INPUT
DC Power
R: 24 V DC
(Operational voltage range 24 V ±10 %, ripple 10 %p-p max.)
Burnout setting: Selectable between upscale (*) and
downscale with the front DIP switch
(*) Factory default setting
[1] OPTIONS
Linearization: Standard
blank: none
Cold junction compensation: CJC sensor attached to the
input terminals
/Q: Options other than the above (specify the specification)
Status indicator LED: PWR, RUN
SPECIFICATIONS OF OPTION: Q (multiple selections)
COATING (For the detail, refer to M-System's web site.)
/C01: Silicone coating
(Refer to the instruction manual)
/C02: Polyurethane coating
/C03: Rubber coating
R7FN-TS4 SPECIFICATIONS
ES-7808-B Rev.0 Page 1/6
http://www.m-system.co.jp/