MODEL: R7FN-YS2
(No. ESU-7808-YS2)
Remote I/O R7 Series
RELATED PRODUCTS
FLEX NETWORK I/O MODULE
(2 points DC current output, isolated)
Functions & Features
• PC configurator software (model: R7CON)
The configurator software is downloadable at M-System’s
web site.
• 2 points DC current output module for FLEX NETWORK
• Easy parameter setting of individual channels with M-
System's configurator software
A dedicated cable is required to connect the module to the
PC. Please refer to the internet software download site or
the users manual for the PC configurator for applicable
cable types.
FLEX NETWORK is registered trademark of Digital
Electronics Corporation in Japan.
• Screen editor software (model: GP-Pro EX)
Screen editor software GP-Pro EX (Ver.2.70 or higher) is
available.
115 (4.53)
For versions between 2.60 and 2.70, the driver must be
installed. The driver is downloadable at Digital Electronics
Corporation's web site. http://www.proface.co.jp/
53 (2.09)
GENERAL SPECIFICATIONS
Connection: M3 separable screw terminal (torque 0.5 N·m)
Solderless terminal: Refer to the drawing at the end of the
section.
54 (2.13)
mm (inch)
• Communication cable
MODEL: R7FN–YS2-R[1]
Recommended manufacture: Japan Solderless Terminal
MFG.Co.Ltd
ORDERING INFORMATION
• Code number: R7FN-YS2-R[1]
Specify a code from below for [1].
(e.g. R7FN-YS2-R/Q)
Applicable wire size: 0.2 to 0.5 mm
2
(AWG 26 to 22)
• Others
Recommended manufacture: Japan solderless terminal
MFG.Co.Ltd, Nichifu Co.,ltd
• Specify the specification for option code /Q
(e.g. /C01/SET)
Applicable wire size: 0.25 to 1.65 mm
2
(AWG 22 to 16)
Screw terminal: Nickel-plated steel
Housing material: Flame-resistant resin (gray)
Isolation: Output 0 to output 1 to FLEX NETWORK to power
to FG
I/O TYPE
YS2: DC current output, 2 points
Zero adjustments: Configurable via R7CON
Span adjustments: Configurable via R7CON
Output at the loss of communication:
Output hold (*), Output clear
POWER INPUT
DC Power
R: 24 V DC
Selectable with the front DIP SW
(*) factory default setting
(Operational voltage range 24 V ±10 %, ripple 10 %p-p max.)
Status indicator LED: PWR, RUN
(Refer to the instruction manual)
■Recommended solderless terminal
[1] OPTIONS
blank: none
/Q: Options other than the above (specify the specification)
3.3 (.13) max
SPECIFICATIONS OF OPTION: Q (multiple selections)
COATING (For the detail, refer to M-System's web site.)
/C01: Silicone coating
mm (inch)
/C02: Polyurethane coating
/C03: Rubber coating
EX-FACTORY SETTING
/SET: Preset according to the Ordering Information Sheet
R7FN-YS2 SPECIFICATIONS
ES-7808-E Rev.0 Page 1/5
http://www.m-system.co.jp/