MODEL: R7FN-YV2
EX-FACTORY SETTING
Remote I/O R7 Series
/SET: Preset according to the Ordering Information Sheet
(No. ESU-7808-YV2)
FLEX NETWORK I/O MODULE
(2 points DC voltage output, isolated)
Functions & Features
RELATED PRODUCTS
• PC configurator software (model: R7CON)
The configurator software is downloadable at M-System’s
web site.
• 2 points DC voltage output module for FLEX NETWORK
• Output range can be selected with the front DIP switches
for all channels.
A dedicated cable is required to connect the module to the
PC. Please refer to the internet software download site or
the users manual for the PC configurator for applicable
cable types.
• Easy parameter setting of individual channels with M-
System's configurator software
FLEX NETWORK is registered trademark of Digital
Electronics Corporation in Japan.
• Screen editor software (model: GP-Pro EX)
Screen editor software GP-Pro EX (Ver.2.70 or higher) is
available.
115 (4.53)
For versions between 2.60 and 2.70, the driver must be
installed. The driver is downloadable at Digital Electronics
Corporation's web site. http://www.proface.co.jp/
53 (2.09)
GENERAL SPECIFICATIONS
Connection: M3 separable screw terminal (torque 0.5 N·m)
Solderless terminal: Refer to the drawing at the end of the
section.
54 (2.13)
mm (inch)
• Communication cable
MODEL: R7FN–YV2-R[1]
Recommended manufacture: Japan Solderless Terminal
MFG.Co.Ltd
ORDERING INFORMATION
• Code number: R7FN-YV2-R[1]
Specify a code from below for [1].
(e.g. R7FN-YV2-R/Q)
Applicable wire size: 0.2 to 0.5 mm
2
(AWG 26 to 22)
• Others
Recommended manufacture: Japan solderless terminal
MFG.Co.Ltd, Nichifu Co.,ltd
• Specify the specification for option code /Q
(e.g. /C01/SET)
Applicable wire size: 0.25 to 1.65 mm
2
(AWG 22 to 16)
Screw terminal: Nickel-plated steel
Housing material: Flame-resistant resin (gray)
Isolation: Output 0 to output 1 to FLEX NETWORK to power
to FG
I/O TYPE
YV2: DC voltage output, 2 points
Zero adjustments: Configurable via R7CON
Span adjustments: Configurable via R7CON
Output range: Selectable with the front DIP SW or
configurable via R7CON
POWER INPUT
DC Power
R: 24 V DC
Output at the loss of communication:
Output hold (*), Output clear
(Operational voltage range 24 V ±10 %, ripple 10 %p-p max.)
Selectable with the front DIP SW
(*) factory default setting
[1] OPTIONS
Status indicator LED: PWR, RUN
blank: none
(Refer to the instruction manual)
■Recommended solderless terminal
/Q: Options other than the above (specify the specification)
3.3 (.13) max
SPECIFICATIONS OF OPTION: Q (multiple selections)
COATING (For the detail, refer to M-System's web site.)
/C01: Silicone coating
/C02: Polyurethane coating
mm (inch)
/C03: Rubber coating
R7FN-YV2 SPECIFICATIONS
ES-7808-D Rev.0 Page 1/6
http://www.m-system.co.jp/