MODEL: R3-SV8
Remote I/O R3 Series
CAUTION
■ UNUSED INPUT CHANNELS
Set the unused channels to the ranges otherthan 1 – 5 V.
Otherwise, set them as “Unused” with PC Configurator
software: R3CON. Unused channels left open with 1 – 5 V
setting are equal to the input lower than -15 %, which sets a
data abnormality at the PLC or the host device.
DC VOLTAGE INPUT MODULE
(8 points, isolated)
27.5 [1.08]
GENERAL SPECIFICATIONS
Connection
130
[5.12]
Internal bus: Via the Installation Base (model: R3-BSx)
Input: M3 separable screw terminal (torque 0.5 N·m)
Internal power: Via the Installation Base
(model: R3-BSx)
109
[4.29]
mm [inch]
Screw terminal: Nickel-plated steel
Isolation: Input 1 to input 2 to input 3 to input 4 to input 5 to
input 6 to input 7 to input 8 to internal bus or internal power
Input range: Selectable with the side DIP SW (per 4
channels)
MODEL: R3-SV8[1][2]
ORDERING INFORMATION
• Code number: R3-SV8[1][2]
Conversion rate: Selectable with the side DIP SW
RUN indicator: Bi-color (red/green) LED;
Red when the bus A operates normally;
Green when the bus B operates normally;
Amber when both buses operate normally.
ERR indicator: Bi-color (red/green) LED;
Red with input circuit abnormality (AD converter response
failure);
Specify a code from below for each of [1] and [2].
(e.g. R3-SV8W/CE/Q)
• Specify the specification for option code /Q
(e.g. /C01/SET)
NO. OF CHANNELS
8: 8
Green in normal operating conditions.
[1] COMMUNICATION MODE
S: Single
INPUT SPECIFICATIONS
■ Narrow Span: -1 – +1 V, 0 – 1 V DC
Input resistance: 100 kΩ min.
■ Wide Span: -10 – +10 V, -5 – +5 V,
0 – 10 V, 0 – 5 V, 1 – 5 V DC
W: Dual
[2] OPTIONS (multiple selections)
Standards & Approvals
blank: Without CE
Input resistance: 1 MΩ min.
/CE: CE marking
INSTALLATION
Other Options
Operating temperature: -10 to +55°C (14 to 131°F)
Operating humidity: 30 to 90 %RH (non-condensing)
Atmosphere: No corrosive gas or heavy dust
Mounting: Installation Base (model: R3-BSx)
Weight: 250 g (0.55 lb)
blank: none
/Q: Option other than the above (specify the specification)
SPECIFICATIONS OF OPTION: Q (multiple selections)
COATING (For the detail, refer to M-System's web site.)
/C01: Silicone coating
PERFORMANCE
Conversion accuracy: Refer to the table at the end of this
/C02: Polyurethane coating
/C03: Rubber coating
section.
EX-FACTORY SETTING
Conversion rate: 160 / 80 / 40 / 20 msec. selectable
Data range: 0 – 10000 of the input range
Data allocation: 8
/SET: Preset according to the Ordering Information Sheet
(No. ESU-8367)
Current consumption: 100 mA
R3-SV8 SPECIFICATIONS
ES-8367 Rev.11 Page 1/3
https://www.m-system.co.jp/