PONA 2100 Series
DATASHEET | JANUARY 2012
FIBER OPTICS
Optical/Electrical Characteristics1
Symbol
(Units)
Property
Limit
PONA Models
Comments
2114
2117
2120
2122
2124
2127
2130
Operating Input Power
Operating Input Power
Pin (dBm)
Pin (dBm)
Max
Min
+12
+12
+12
+12
+12
+12
+12
Typical
(May vary for
some models)
-10
-10
-10
-10
-10
-10
-10
14.0
17.0
20.0
22.0
24.0
27.0
30.0
Output Power
Noise Figure
Po (dBm)
NF (dB)
(Note 2)
+/-.25
+/- .25
+/- .25
+/- .25
+/- .25
+/- .25
+/- .25
Typ/Ma
x
4.5/5.0
4.5/5.0
4.5/5.0
4.5/5.0
5.0/5.5
5.0/5.5
5.5/6.0
(Notes 3, 8)
Static Gain Flatness
Dynamic Gain Flatness
Output Power Stability
GF (dB)
(dB)
Max
Max
Max
+/-0.5
+/-1
+/-0.5
+/-1.25
+/- 0.2
+/-0.5
+/-1.5
+/- 0.2
+/-0.5
+/-2.0
+/- 0.2
+/-0.5
+/-2.0
+/- 0.2
+/-0.5
+/-2.0
+/- 0.2
(Note 7)
(Note 7)
+/- 0.2
(Note 4)
(Notes 5, 8)
(Note 6)
(dB)
+/- 0.2
Power Consumption
(steady state regime)
Psys (W)
Max
5
7
9
12
20
35
40
50oC Case
Notes:
1. Unless stated otherwise, all specifications apply over the full operating temperature and humidity ranges
2. Measurement variations
3. Measured with 8 evenly spread input optical signals @ 25°C, Pin ≈ 0 dBm (Measuring with 1 input optical signal with Pin ≈ 0 dBm
and ≈ 1550 nm is also possible. (Low Noise Figure options with NF ≤ 4.0/4.5 dB are available for some models)
4. Measured with a swept Probe Signal (Pp), where Pp ≈ 0 dBm @ 25C
5. Measured with a swept Probe Signal (Pp), and a fixed Tone Signal (Pt) @ ~ 1550 nm; (Pt ≈ Pp+20 dB; Pt + Pp ≈ 0 dBm) @ 25C;
Gain Flattened Options with ΔG ≤ +/-1.0dB are available (for some models)
6. Over polarization and temperature
7. Static and Dynamic Gain Flatness for PONA 2130 can be defined for 1545 nm ≤ ≤1562 nm and by special request only.
8. Specific NF and ΔG can be guaranteed at a single specified Input Optical Power Level (Pin = Pt + Pp) equal or different from 0 dBm.
(Please contact your Sales Representative for more information)
|
REV 2012.01
Information contained herein is deemed reliable and accurate as of the issue date. EMCORE reserves the right to change the design or specification at any time without notice.