554 SERIES
n
9.0 CONNECTION AND MOUNTING
The details below indicate the recommended mounting structure for panel and enclosure. The enclosure sup-
port to fix the touch panel must be over 1.0mm I width and must be outside the view (Transparent area). Also
ensure that the enclosure does not cause miss input by touching the view area.
The following diagram shows that the enclosure edge must be between the View area and the guaranteed ac-
tive area. Ensure space is allocated for the diodes, and we recommend that the material to fix the panel and
enclosure is elastic. Special design would be required to stop water ingress. The corners of the touch panel
are conductive so do not touch any metal parts after mounting.
Top View (Picture, with conductive
side down)
Location
Detect
1.
2.
3.
4.
Bottom
Left
Top
Stiffener board 10.2
5.1
Right
(Mating connector type FCI or equivalent
SFW4R-1STAE1-LF: for FPC)
(Drawing) with conductive connector and glass
side down. See page 1 for detail of connector exit
side which is left.
Transparent Area
Anti-input Area
0.8 mm min.
Upper Case
Input Area
Shock absorber to protect
the panel (eg rubber)
Input Panel
View Area
Wiring Area
1.0 to 3.0 mm
Shock absorber
for protection
LCD
Connector
Circuit Board
6