FID-550 SERIES
n
9.0 CONNECTION AND MOUNTING
The details below indicate the recommended mounting structure for panel and enclosure. The enclosure sup-
port to fix the touch panel must be over 1.0mm I width and must be outside the view (Transparent area). Also
ensure that the enclosure does not cause miss input by touching the view area.
The following diagram shows that the enclosure edge must be between the View area and the guaranteed ac-
tive area. Ensure space is allocated for the diodes, and we recommend that the material to fix the panel and
enclosure is elastic. Special design would be required to stop water ingress. The corners of the touch panel
are conductive so do not touch any metal parts after mounting.
Top View (Picture, with conductive
side down)
Location
Detect
1.
2.
3.
4.
5.
6.
7.
Right/ Upper
Right/ Upper
Each side
Left/ Lower
Each side
Glass
Glass
Glass
Glass
Glass
Glass
0.7
3.35
Stiffener Board
Left/ Lower
All
Film
Laminate Film
Conductive Face
FPC-type cable
Contact Section View
Bottom View (Drawing, with conductive side up)
(Mating connector type FCI or equivalent SFW15R-1STAE1-LF: for FPC)
Transparent Area
Anti-input Area
0.8 mm min.
Cut-out / avoidance of
550 surface mount diodes
Input Area
Upper Case
Shock absorber to protect
the panel (eg rubber)
Input Panel
Wiring Area
1.0 to 3.0 mm
View Area
Shock absorber
for protection
LCD
Connector
Circuit Board
6