FID-550 SERIES
n
7.0 REJECT CRITERIA
Description
Reject Criteria
Area ≥ 0.1mm2
: to be zero
: to be max. 5 points
: none specified
Film Dent
Area ≥ 0.05mm2 & area < 0.1mm2
Area < 0.05mm2
Area > 0.1mm2
: to be zero
: to be max. 5 points
: none specified
Dot type Area ≥ 0.05mm2 & area < 0.1mm2
Area < 0.05mm2
Foreign
material
between
glass and film
Area > 0.1mm
: to be zero
Line type Area ≥ 0.03mm & width <0.1mm and length < 10mm : to be max. 1 point
Area < 0.05mm
: none specified
Area ≥ 0.1mm
: to be zero
Scratch
Area ≥ 0.03mm & width <0.1mm with length < 80mm : to be max. 1 point
Area < 0.03mm & width <0.1mm with length < 30mm : none specified
Area ≥ 0.5mm2
: to be zero
: to be max. 5 points
: none specified
Dot blur or hard coat
missing
Area ≥ 0.03mm2 & area < 0.5mm2
Area < 0.05mm2
These must not be seen from Panel film side under a fluorescent lamp (3
wavelength type lamp). Not to be verified form glass side.
Newton Ring
Glass flaw
To be no flaw which is bigger than that shown in the following diagram. The
number of flaws is not specified.
3mm
5mm
2mm
2mm
n
8.0 GENERAL POINTS OF CAUTION
Touch panels are made of glass, so care must be taken in handling them. Do not stress, pile, bend, lift by
the cable or put any stress on the film, for example moving by film face vacuum. In order to clean wring dry a
cloth which has been emersed in a natural detergent. DO NOT use any organic solvent, acid or alkali solu-
tion. Watch the edge of the panel when cleaning, again for safety reasons.
5