MSM7580

更新时间： 2024-01-29 10:11:37

阅读下载

获取价格

如果您发现信息不准确，欢迎纠错

MSM7580 技术参数

¡ Semiconductor

MSM7580

SYNCP1, SYNCP2

Synchronous signal input.

SYNCP1 and SYNCP2 control the PCM data input/output timing for Channel 1 (SIP1, SOP1)

and Channel 2 (SIP2, SOP2), respectively.

SinceothersynchronoussignalinputpinsSYNCA1andSYNCA2forADPCMinterfacesarealso

provided, the PCM and ADPCM data can be input or output with different timing.

PCM and ADPCM data interfaces can be used at a mutually independent timing except same

timing.

Note: When PCM and ADPCM data interfaces are used at a mutually independent timing, the

timing described in "Notes on Usage" should not be used.

BCLKP

Bit clock input.

This signal defines the PCM data transmission speed at the PCM data input/output pins.

BCLKP is used for Channels 1 and 2. Since BCLKA defines the data rate of the ADPCM data

interface, the PCM and ADPCM data can be input or output at different speeds.

LAW

PCM data companding law (A-law/m-law) selection.

Digital “1” and “0” correspond to A-law and µ-law, respectively.

PDN1, PDN2

Power down mode selection.

PDN1 and PDN2 can be independently set to power down mode. When a digital “0” is applied,

these pins are in the power-down mode.

SIA1, SOA1

ADPCM serial data input (SIA1) and output (SOA1) pins for Channel 1.

SOA1 is an open-drain pin and enters to the high impedance state after outputting a continuous

4-bit serial data stream. When the data-through mode is selected, SOA1 enters to the high

impedance state after outputting an 8-bit serial data stream.

SIA2, SOA2

ADPCM serial data input (SIA2) and output (SOA2) pins for Channel 2.

These pins function the same as SIA1 and SOA1.

5/17

1 2 3 456 7 8...18

下载PDF

型号	品牌	描述	获取价格	数据表
MSM7580GS-K	OKI	暂无描述	获取价格
MSM7581	OKI	ITU-T G.721 4ch ADPCM TRANSCODER	获取价格
MSM7581TS-K	OKI	暂无描述	获取价格
MSM7582	OKI	pie/4 Shift QPSK MODEM	获取价格
MSM7582B	OKI	pie/4 Shift QPSK MODEM	获取价格
MSM7582TS-K	OKI	Modem, 384kbps Data, CMOS, PDSO32, 8 X 14 MM, 0.50 MM PITCH, PLASTIC, TSOP1-32	获取价格