MP3362 – SINGLE-STRING, 3V MINIMUM Vin, 36V BOOST LED DRIVER
PIN FUNCTIONS
Pin #
Name Description
Output switch node. SW is the drain of the internal N-channel MOSFET. Connect the
inductor and rectifier to SW to complete the boost converter.
1
SW
VIN
Input supply pin. This pin can be connected to the regulator’s input supply or to the output
for bootstrap operation.
2
3
Error amplifier output compensation. Connect the COMP pin to a series RC network to
compensate the regulator control loop.
COMP
Enable and dimming pin. Used the EN/DIM pin to enable/disable the device, or to initiate
PWM dimming or analog dimming. The following conditions determine how this pin operates:
EN/
DIM
4
1. Keep the EN/DIM pin low for 20ms to disable the IC.
2. Apply a <2kHz PWM signal frequency to make the IC work in PWM dimming mode.
3. Apply a >5kHz PWM signal frequency to make the IC work in analog dimming mode.
Switching frequency setting and synchronization pin. Connect a resistor to this pin to
program the switching frequency. Apply a pulse signal between 200kHz and 2.2MHz to
synchronize the switching frequency.
OSC/
SYNC
5
6
7
8
FB
Regulation feedback input. The regulation threshold is 0.2V.
Open LED protection pin. OVP pin senses the output voltage to protect the IC during open
LED operation.
OVP
GND Ground.
MP3362 Rev. 1.1
2/22/2023
www.MonolithicPower.com
MPS Proprietary Information. Patent Protected Unauthorized Photocopy and Duplication Prohibited.
© 2023 MPS. All Rights Reserved.
3