MC13077
PIN DESCRIPTIONS (continued)
Description
Internal Equivalent
Schematic
Pin
Symbol
Expected Waveforms
1.0 Vpp with sync
10
Y
Out
Luminance Delay Line Drive Output. A
delay should be inserted between this
pin and Pin 6 to match the delay incurred
by the Chroma.
10 k
(100% saturated Color Bar output).
10 k
1.4 V
11
12
Gnd
Ground
Ground
Red
In
Red Video input.
0.7 Vpp AC coupled (100% Color Bars).
20 k
V
ref
13
14
15
Green
In
See Pin 12
See Pin 12
Green Video input.
Blue Video input.
0.7 Vpp AC coupled (100% Color Bars).
0.7 Vpp AC coupled (100% Color Bars).
Blue
In
B–Y
B–Y Clamp storage capacitor. A 0.01 µF If not used as an input the pin is clamped
Clamp
capacitor should be connected from this
pin to ground, unless the pin is used as
an input.
during sync to 2.4 Vdc. Can be used as a
B–Y input (AC coupled, 350 mVpp, 100%
color saturation). Burst Flag, if disabled
at Pin 18, must be inserted here with the
following signal levels; –170 mV (NTSC),
–121 mV (PAL).
16
17
R–Y
Clamp
R–Y Clamp storage capacitor. A 0.01 µF If not used as an input the pin is clamped
capacitor should be connected from this
pin to ground, unless the pin is used as
an input.
during sync to 2.4 Vdc. Can be used as a
R–Y input (AC coupled, 490 mVpp, 100%
color saturation). Burst Flag, if disabled
at Pin 18, must be inserted here with the
following signal level; +121 mV for PAL.
Chroma
Out
Chroma Bandpass Drive Output.
2.8 Vpp (100% Color Bars)
V
CC
18
Burst Flag
Out/Force
Burst Flag
Burst Flag Output Disable and Force pin. 1.8 Vpp burst flag pulses if unconnected.
If left unconnected, internally generated
color burst will appear at Pins 2 and 4.
Burst Flag will appear at this pin (18). If
grounded, the Burst Flag will be
disabled. If externally driven from
another source of burst flag, the internal
flags will be overriden.
Internal
Burst
Flag
10 k
1/2 V
CC
19
20
PAL
Square–
wave
Out/Force
NTSC
PAL/NTSC system switch. If grounded,
the MC13077 will encode NTSC, and if
left open, PAL.
In PAL mode, a PAL squarewave
appears at this pin, the phase of which
can be reset by momentarily forcing the
pin to ground during the high state of
the squarewave.
V
CC
1.4 V
Chroma
In
Chroma Bandpass input. Output from
chroma bandpass filter should be
applied at this pin.
1.4 Vpp (100% Color Bars) with
bandpass filter and 1.0 kΩ matching
resistors.
10 k
10 k
2.0 V
5
MOTOROLA ANALOG IC DEVICE DATA