MAX97002 Evaluation Kit
4) Verify that a shunt is installed on jumper JU3.
MAX97002 EV Kit Files
5) Connect the USB cable from the PC to the EV kit
board. A New Hardware Found window pops up
when installing the USB driver for the first time.
If a window is not seen that is similar to the one
described above after 30s, remove the USB cable
from the board and reconnect it. Administrator privi-
leges are required to install the USB device driver
on Windows.
FILE
DESCRIPTION
Installs the EV kit files on your
computer
INSTALL.EXE
MAX97000_1_2.EXE
FTD2XX.INF
Application program
USB device driver file
Uninstalls the EV kit software
UNINST.INI
USB_Driver_Help.PDF USB driver installation help file
6) Follow the directions of the Found New Hardware
window to install the USB device driver. Manually
specify the location of the device driver to be
Quick Start
C:\Program Files\MAX97000_1_2 (default instal-
lation directory) using the Browse button. During
device driver installation, Windows may show a
warning message indicating that the device driver
Maxim uses does not contain a digital signature.
This is not an error condition and it is safe to pro-
ceed with installation. Refer to the USB_Driver_
Help.PDF document included with the software for
additional information.
Required Equipment
•ꢀ 5V, 1A DC power supply (PVDD)
•ꢀ 1.8V, 100mA DC power supply (VDD)
•ꢀ Speaker
•ꢀ Headphones
•ꢀ User-supplied Windows 2000, Windows XP, or
Windows Vista PC with a spare USB port
•ꢀ MAX97002 EV kit (cable included)
7) Connect the 5V power supply across the PVDD and
GND pads.
Note: In the following sections, software-related items
are identified by bolding. Text in bold refers to items
directly from the EV kit software. Text in bold and under-
lined refers to items from the Windows operating system.
8) Connect the 1.8V power supply across the VDD and
GND pads.
9) Connect the speaker across the OUT+ and OUT-
test points.
Procedure
The MAX97002 EV kit is fully assembled and tested.
Follow the steps below to verify board operation:
10) Connect the headphones to HPJK.
11) Enable the power supplies.
1) Visit www.maxim-ic.com/evkitsoftware to down-
load the latest version of the EV kit software,
MAX97000_1_2xx.ZIP. Save the EV kit software to a
temporary folder and uncompress the ZIP file.
12) Start the MAX97002 EV kit software by selecting its
icon in the Start | Programs menu.
13) Observe as the program automatically detects the
address of the MAX97002 and starts the main pro-
gram.
2) Install the EV kit software on the computer by run-
ning the INSTALL.EXE program inside the tempo-
rary folder.
14) The MAX97002 is now ready for evaluation.
3) Verify that shunts are installed on jumpers JU1 and
JU2. This configures the I2C inputs to receive sig-
nals from the USB interface circuitry.
_______________________________________________________________________________________
3