5秒后页面跳转
MAX5930EEG+ PDF预览

MAX5930EEG+

更新时间: 2024-10-03 13:10:43
品牌 Logo 应用领域
美信 - MAXIM 控制器
页数 文件大小 规格书
23页 482K
描述
暂无描述

MAX5930EEG+ 数据手册

 浏览型号MAX5930EEG+的Datasheet PDF文件第2页浏览型号MAX5930EEG+的Datasheet PDF文件第3页浏览型号MAX5930EEG+的Datasheet PDF文件第4页浏览型号MAX5930EEG+的Datasheet PDF文件第5页浏览型号MAX5930EEG+的Datasheet PDF文件第6页浏览型号MAX5930EEG+的Datasheet PDF文件第7页 
19-3032; Rev 0; 10/03  
Low-Voltage, Triple, Hot-Swap Controllers/  
Power Sequencers/Voltage Trackers  
General Description  
Features  
The MAX5930/MAX5931 +1V to +13.2V triple hot-swap  
controllers provide complete protection for multisupply  
systems. They allow the safe insertion and removal of  
circuit cards into live backplanes. These devices hot  
swap multiple supplies ranging from +1V to +13.2V,  
provided one supply is at or above +2.7V and only one  
supply is above 11V. The input voltage rails (channels)  
can be configured to sequentially turn-on/off, track  
each other, or have completely independent operation.  
Safe Hot Swap for +1V to +13.2V Power Supplies  
with Any Input Voltage (V ) 2.7V and Only One  
IN_  
V
> 11.0V  
IN_  
Adjustable Circuit Breaker/Current-Limit  
Threshold from 25mV to 100mV  
Configurable Tracking, Sequencing, or  
Independent Operation Modes  
VariableSpeed/BiLevel Circuit-Breaker Response  
The discharged filter capacitors of the circuit card pro-  
vide low impedance to the live backplane. High inrush  
currents from the backplane to the circuit card can burn  
up connectors and components, or momentarily collapse  
the backplane power supply leading to a system reset.  
The MAX5930/MAX5931 hot-swap controllers prevent  
such problems by gradually ramping up the output volt-  
age and regulating the current to a preset limit when the  
board is plugged in, allowing the system to stabilize  
safely. After the startup cycle is complete, on-chip com-  
parators provide VariableSpeed/BiLevel™ protection  
against short-circuit and overcurrent faults, and provide  
immunity against system noise and load transients.  
Internal Charge Pumps Generate N-Channel  
MOSFET Gate Drives  
Inrush Current Regulated at Startup  
Autoretry or Latched Fault Management  
Programmable Undervoltage Lockout  
Status Outputs Indicate Fault/Safe Condition  
Ordering Information  
PART  
TEMP RANGE  
-40°C to +85°C  
-40°C to +85°C  
-40°C to +85°C  
PIN-PACKAGE  
24 QSOP  
MAX5930EEG  
MAX5931LEEP*  
MAX5931HEEP*  
20 QSOP  
The load is disconnected in the event of a fault condi-  
tion. The MAX5930/MAX5931 fault-management mode  
is selectable, allowing latched fault or autoretry after a  
fault condition.  
20 QSOP  
*Future product—contact factory for availability.  
Selector Guide and Typical Operating Circuit appear at end  
of data sheet.  
The MAX5930/MAX5931 offer a variety of options to  
reduce external component count and design time. All  
devices integrate an on-board charge pump to drive  
the gates of low-cost, external N-channel MOSFETs, an  
adjustable startup timer, and an adjustable current limit.  
The devices offer integrated features like startup cur-  
rent regulation and current glitch protection to eliminate  
external timing resistors and capacitors. The  
MAX5931L provides an open-drain, active-low status  
output for each channel, the MAX5931H provides an  
open-drain, active-high status output for each channel,  
and the MAX5930 status output polarity is selectable.  
Pin Configurations  
TOP VIEW  
POL  
ON2  
1
2
3
4
5
6
7
8
9
24 MODE  
23 ON3  
ON1  
22 LIM2  
21 IN2  
LIM1  
MAX5930  
IN1  
20 SENSE2  
19 GATE2  
18 LIM3  
17 IN3  
SENSE1  
GATE1  
STAT1  
STAT2  
The MAX5930 is available in a 24-pin QSOP package,  
and the MAX5931 is available in a 20-pin QSOP pack-  
age. All devices are specified over the extended -40°C  
to +85°C temperature range.  
16 SENSE3  
15 GATE3  
14 GND  
13 BIAS  
TIM 10  
LATCH 11  
STAT3 12  
Applications  
Network Switches, Routers, Power-Supply  
Hubs  
Sequencing/Tracking  
Hot Plug-In Daughter Cards Base-Station Line Cards  
QSOP  
RAID  
Portable Computer Device  
Bays (Docking Stations)  
Pin Configurations continued at end of data sheet.  
Solid-State Circuit Breakers  
VariableSpeed/BiLevel is a trademark of Maxim Integrated  
Products, Inc.  
________________________________________________________________ Maxim Integrated Products  
1
For pricing, delivery, and ordering information, please contact Maxim/Dallas Direct! at  
1-888-629-4642, or visit Maxim’s website at www.maxim-ic.com.  

与MAX5930EEG+相关器件

型号 品牌 获取价格 描述 数据表
MAX5930EEG+T MAXIM

获取价格

Power Supply Support Circuit, Adjustable, 3 Channel, BICMOS, PDSO24, 0.150 INCH, 0.635 MM
MAX5930EEG-T MAXIM

获取价格

Power Supply Support Circuit, Adjustable, 3 Channel, BICMOS, PDSO24, 0.150 INCH, 0.635 MM
MAX5931A MAXIM

获取价格

Low-Voltage, Triple, Hot-Swap Controllers/ Power Sequencers/Voltage Trackers
MAX5931AEEP+ MAXIM

获取价格

Low-Voltage, Triple, Hot-Swap Controllers/ Power Sequencers/Voltage Trackers
MAX5931B MAXIM

获取价格

Low-Voltage, Triple, Hot-Swap Controllers/ Power Sequencers/Voltage Trackers
MAX5931B ADI

获取价格

低电压、三路、热插拔控制器/供电排序器/电压跟踪器
MAX5931BEEP+ MAXIM

获取价格

Low-Voltage, Triple, Hot-Swap Controllers/ Power Sequencers/Voltage Trackers
MAX5932 MAXIM

获取价格

MAX5932 Evaluation Kit
MAX5932 ADI

获取价格

正电源、高压、热插拔控制器
MAX5932ESA MAXIM

获取价格

MAX5932 Evaluation Kit