Click here for production status of specific part numbers.
Evaluates: MAX38903A/MAX38903B
MAX38903 TDFN Evaluation Kit
General Description
Quick Start
The MAX38903 TDFN evaluation kit (EV kit) evaluates
the MAX38903A/MAX38903B IC family of low noise linear
regulators. The EV kit operates over an input range of
1.7V to 5.5V and provides any output voltage range from
0.6V to 5.3V, and delivers up to 1A of current. The EV kit
comes with the MAX38903BATB+ installed.
Required Equipment
●
●
●
●
MAX38903 TDFN EV kit
5.5V, 1A DC power supply
Electronic load capable of 1A
Digital voltmeter (DVM)
Features
Procedure
● Evaluates the MAX38903A/MAX38903B IC in a
The EV kit is fully assembled and tested. Follow the steps
below to verify board operation.
10-pin (3mm x 3mm) TDFN
● 1.7V to 5.5V Input Range
Caution:Donotturnonpowersupplyuntilallconnections
are completed.
● 0.6V to 5.3V Resistor Configurable Output Voltage
(MAX38903B, On Board with Output Set to 3.3V)
1) Verify that jumpers JU101, SELA and SELB are in
their default positions, as shown in Tables 1, 2, and 3.
2) Connect the 5.5V power supply between the IN and
nearest GND terminal posts.
3) Connect the 1A electronic load between the OUT
and nearest GND terminal posts.
4) Connect the DVM between the OUT and nearest
GND terminal posts.
5) Turn on the power supply.
● 1.2V to 5.0V Jumper Configurable Output Voltage
(MAX38903A, with IC Replacement)
● Up to 1A Output Current
● Proven 2-Layer 1 oz Copper PCB Layout
● Demonstrates Compact Solution Size
● Fully Assembled and Tested
6) Enable the electronic load.
7) Verify that the voltage at the OUT terminal post is
approximately 3.3V.
Ordering Information appears at end of data sheet.
MAX38903 TDFN EV Kit Files
FILE
DECRIPTION
EV Kit Bill of Material
EV Kit Layout
MAX38903 TDFN EV Kit BOM
MAX38903 TDFN EV Kit PCB Layout
MAX38903 TDFN EV Kit Schematic
EV Kit Schematic
319-100262; Rev 0; 10/18