EVALUATION KIT AVAILABLE
Click here to ask about production status of specific part numbers.
MAX22195
High-Speed, Octal, Industrial Digital Input
with Parallel Output
General Description
Benefits and Features
● High-Speed, Industrial Digital Inputs
The MAX22195 translates eight 24V industrial digital inputs
to eight CMOS-compatible, parallel outputs. Propagation
delay from input-to-output is less than 300ns for all channels.
Current-limiters on each digital input greatly reduce power
dissipation compared to traditional resistive inputs. The
accuracy of these current-limiters minimizes power
dissipation while ensuring compliance with the IEC
61131-2 standard. A current-setting resistor allows the
MAX22195 to be configured for Type 1, Type 2, or Type
3 inputs. Additionally, the MAX22195 has energyless field-
side LED drivers to meet the indicator light requirement of
IEC 61131-2 with no additional power dissipation.
• 300ns Maximum Propagation Delay
• ±10ns Maximum Channel-to-Channel Skew
• Parallel Output for Simultaneous Signal Delivery
● High Integration Reduces BOM Count and Board Space
• Operates Directly from Field Supply (7V to 65V)
• Compatible with 3.3V or 5V Logic
• 5mm x 5mm, 32-TQFN Package
● Low Power and Low Heat Dissipation
• Low Quiescent Current (1.2mA Maximum)
• Accurate Input Current-Limiters
• Energyless Field-Side LED Drivers
The MAX22195 provides a 3.3V integrated voltage
regulator. The internal LDO accepts the field supply
● Fault Tolerant with Built-In Diagnostics
• Integrated Field-Side Supply Monitor
• Integrated Over-Temperature Monitor
• Current-Setting Resistor Monitor
V
DD24
from 7V to 65V. The internal LDO output can
supply up to 25mA of current in addition to powering the
basic MAX22195 requirements. This MAX22195 LDO
current can be used to power digital isolators and other
field-side circuits. Alternatively, the MAX22195 can be powered
● Configurability Enables Wide Range of Applications
• Configurable IEC 61131-2 Types 1, 2, 3 Inputs
• Configurable Input Current Limiting from 0.56mA to
3.97mA
from a 3.0V to 5.5V supply connected to V
pin.
DD3
The MAX22195 includes an open-drain READY output
that asserts high to indicate the MAX22195 is functional.
● Robust Design
If the V
field-side supply voltage is too low, or a fault
DD24
• ±1kV Surge Tolerant using Minimum 1kΩ Resistor
• ±8kV Contact ESD and ±15kV Air Gap ESD Using
Minimum 1kΩ Resistor
in the current-setting resistor is detected, or the device
reaches an over-temperature condition, the READY sig-
nal is set to high-impedance.
• -40°C to +125°C Ambient Operating Temperature
Applications
● Programmable Logic Controllers
● Industrial Automation
● Process Automation
Ordering Information appears at end of data sheet.
● Building Automation
19-100330; Rev 6; 3/21