MODEL: MATP
Line: M5 screw terminal (torque: 2.5 N·m)
Lightning Surge Protectors for
Electronics Equipment M-RESTER
Alarm output: Tension clamp
Applicable wire size
Line: See the drawing below.
Alarm output: 0.13 to 1.5 mm
Screw terminal
SURGE PROTECTOR FOR PHOTOVOLTAIC SYSTEM
Functions & Features
2, stripped length 8 mm
• Surge protection for photovoltaic array and power
conditioner.
Line: Nickel-plated steel
Alarm output: Tin-plated copper alloy
Housing material: Flame-resistant resin (black)
Alarm output: Trips when the thermal breaker operates.
(N.C. contact)
•High discharge current capacity 20 kA or 40 kA (8/20 μs)
• Degraded head element is automatically separated from
the power lines by the incorporated thermal breaker, and
the LED lamp (turns off) and the relay contact alerts the
failure status.
Rated load:
250 V AC @50 mA (resistive load)
• Breakdown of the surge protector remotely detected with
the alarm output
24 V DC @50 mA (resistive load)
Safety function: Thermal breaker incorporated
Monitor LED: Green LED turns on during normal conditions
between 150 and 600 V DC, and turns off during failure
condition, power off and the thermal breaker operating.
• Applicable Solderless Terminal Size
diameter d
d : M5 use
B ≤ 13.0 mm
F ≥ 7.0 mm
(F ≥ 8.2 mm for sharing terminals)
T ≤ 1.8 mm
F
MODEL: MATP–600[1][2]
INSTALLATION
ORDERING INFORMATION
• Code number: MATP-600[1][2]
Specify a code from below for each [1] and [2].
(e.g.MATP-600MA)
Operating temperature: -25 to +80°C (-13 to +176°F)
Operating humidity: 30 to 90 %RH (non-condensing)
Mounting: DIN Rail
Weight
MATP-600Mx: 200 g (0.44 lb)
MATP-600Hx: 250 g (0.55 lb)
OPERATIONAL VOLTAGE
600: 600 V DC
PERFORMANCE
[1] MAXIMUM DISCHARGE CURRENT
M: 20kA (8/20 μsec.)
Max. continuous operating voltage (Uc): 600 V DC
Discharge voltage: (Line to earth) 600 V DC
Maximum surge voltage: 2.5 kV
Maximum (Imax) and Nominal (In) discharge current: (8/ 20
μs)
H: 40kA (8/20 μsec.)
[2] ALARM OUTPUT
A: With
• MATP-600Mx: 20 kA (Imax), 10 kA (In)
• MATP-600Hx: 40 kA (Imax), 20 kA (In)
Response time: ≤ 4 nsec
Y: Without
Leakage current: ≤ 1 mA
GENERAL SPECIFICATIONS
Construction: Standalone; terminal access at the front
Degree of protection: IP20 (If the solderless terminals are
covered with insulation tubes.)
Insulation resistance: ≥ 100 MΩ with 500 V DC (line to
alarm output)
Dielectric strength: 2000 V AC @ 1 minute (line to alarm
output)
Surge protection type: Voltage limiting type one-port SPD
Connection
Surge protection: IEC 61643-1 Class II
MATP SPECIFICATIONS
ES-8150 Rev.4 Page 1/3
http://www.m-system.co.jp/