M0519
2
FEATURES
Core
–
–
–
–
–
ARM® Cortex® -M0 core running up to 72 MHz
One 24-bit system timer
Supports Low Power Sleep mode by WFI instructions
Single-cycle 32-bit hardware multiplier
Supports programmable 4 level priorities of Nested Vectored Interrupt Controller
(NVIC)
–
Supports Serial Wire Debug (SWD) support with two watchpoints and four breakpoints
Built-in LDO for wide operating voltage ranged from 2.5V to 5.5V
Memory
–
–
–
–
128K/64K bytes Flash for program memory (APROM)
4KB Flash for data memory (Data Flash)
8KB Flash for loader (LDROM)
Supports In-system program (ISP) and In-application program (IAP) application code
update
–
–
–
Supports 2-wired ICP update through SWD/ICE interface
Supports fast parallel programming mode by external programmer
16K bytes embedded SRAM
Clock Control
–
Built-in 22.1184 MHz internal high speed RC oscillator (HIRC) for system operation
(variation < 2% at -40˚C ~ +105˚C)
–
–
–
–
Built-in 10 kHz internal low speed RC oscillator (LIRC) for Watchdog Timer and wake-
up operation
Built-in 4~24 MHz external high speed crystal oscillator (HXT) for precise timing
operation
Supports one PLL up to 72 MHz for high performance system operation, sourced from
HIRC and HXT
Supports clock output
Hardware divider
–
Supports signed 32-bit dividend, 16-bit divisor operation
GPIO port
–
–
–
–
–
–
–
Four I/O modes:
TTL/Schmitt trigger input selectable
Bit control available
I/O pin configured as interrupt source with edge/level trigger setting
Supports high driver and high sink current I/O (up to 16 mA at 5V)
INT0 and INT1 pins with individual interrupt vectors
Supports up to 82/51/38 GPIOs for LQFP100/64/48 respectively
Timers
–
–
–
Supports 4 sets of 32-bit timers with 24-bit up-timer and one 8-bit prescale counter
Provides One-shot, Periodic, Toggle and Continuous Counting operation modes
Supports event counting function to count the event from external pin
Watchdog Timer
–
–
–
–
–
Supports multiple clock sources from LIRC(default selection) and HCLK/2048
8 selectable time-out period from 1.6ms ~ 26.0sec (depending on clock source)
Able to wake up from Power-down or Idle mode
Interrupt or reset selectable on watchdog time-out
Time-out reset delay period time can be selected
Window Watchdog Timer
Nov. 02, 2016
Page 7 of 69
Rev 1.02