LT1215/LT1216
23MHz, 50V/µs, Single Supply
Dual and Quad
Precision Op Amps
U
DESCRIPTIO
FEATURES
Slew Rate: 50V/µs Typ
TheLT®1215isadual,singlesupplyprecisionopampwith
a 23MHz gain-bandwidth product and a 50V/µs slew rate.
The LT1216 is a quad version of the same amplifier. The
DC precision of the LT1215/LT1216 eliminates trims in
most systems while providing high frequency perfor-
mance not usually found in single supply amplifiers.
■
■
Gain-Bandwidth Product: 23MHz Typ
■
Fast Settling to 0.01%
2V Step to 200µV: 250ns Typ
10V Step to 1mV: 480ns Typ
■
Excellent DC Precision in All Packages
Input Offset Voltage: 450µV Max
Input Offset Voltage Drift: 10µV/°C Max
Input Offset Current: 120nA Max
Input Bias Current: 600nA Max
Open-Loop Gain: 1000V/mV Min
The LT1215/LT1216 will operate on any supply greater
than 2.5V and less than 36V total. These amplifiers are
specified on single 3.3V, single 5V and ±15V supplies, and
only require 5mA of quiescent supply current per ampli-
fier. The inputs can be driven beyond the supplies without
damage or phase reversal of the output. The minimum
outputdriveis30mA,idealfordrivinglowimpedanceloads.
U
■
Single Supply Operation
Input Voltage Range Includes Ground
Output Swings to Ground While Sinking Current
■
Low Input Noise Voltage: 12.5nV/√Hz Typ
APPLICATIO S
■
Low Input Noise Current: 0.5pA/√Hz Typ
■
■
2.5V Full-Scale 12-Bit Systems: VOS ≤ 0.75 LSB
Specified on 3.3V, 5V and ±15V
■
■
10V Full-Scale 16-Bit Systems: VOS ≤ 3 LSB
Large Output Drive Current: 30mA Min
■
■
Active Filters
Photo Diode Amplifiers
DAC Current to Voltage Amplifiers
Low Supply Current per Amplifier: 6.6mA Max
■
■
Dual in 8-Pin DIP and SO-8
■
■
Quad in 14-Pin DIP and NARROW SO-16
■
Battery-Powered Systems
Note: For applications requiring less slew rate, see the LT1211/LT1212 and
LT1213/LT1214 data sheets.
, LTC and LT are registered trademarks of Linear Technology Corporation.
U
TYPICAL APPLICATIO
Single Supply Instrumentation Amplifier
Frequency Response
30
5V
0.1µF
20
DIFFERENTIAL INPUT
NOTE:
–
V
+
10
0
IN
0.1% RESISTORS GIVE CMRR ≥ 68dB.
GAIN IS 10.0V/V.
1/2
LT1215
COMMON MODE INPUT RANGE
IS FROM 0.3V TO 3.0V.
BANDWIDTH IS 2.8MHz.
–10
–20
–30
–40
–
113Ω
1020Ω
113Ω
1020Ω
COMMON MODE INPUT
–50
–60
–70
–
1/2
LT1215
V
OUT
1k
10k
100k
1M
10M
+
V
IN
+
FREQUENCY (Hz)
1215/16 TA01
1215/16 TA02
1