5秒后页面跳转
LT1216 PDF预览

LT1216

更新时间: 2024-02-23 12:28:27
品牌 Logo 应用领域
凌特 - Linear 运算放大器
页数 文件大小 规格书
20页 366K
描述
23MHz, 50V/us, Single Supply Dual and Quad Precision Op Amps

LT1216 技术参数

是否无铅: 含铅是否Rohs认证: 符合
生命周期:Active包装说明:SOP,
针数:16Reach Compliance Code:compliant
风险等级:5.28放大器类型:OPERATIONAL AMPLIFIER
最大平均偏置电流 (IIB):0.8 µA标称共模抑制比:108 dB
最大输入失调电压:750 µVJESD-30 代码:R-PDSO-G16
JESD-609代码:e3长度:9.9 mm
湿度敏感等级:1负供电电压上限:-18 V
标称负供电电压 (Vsup):-15 V功能数量:4
端子数量:16最高工作温度:70 °C
最低工作温度:封装主体材料:PLASTIC/EPOXY
封装代码:SOP封装形状:RECTANGULAR
封装形式:SMALL OUTLINE峰值回流温度(摄氏度):250
认证状态:Not Qualified座面最大高度:1.75 mm
标称压摆率:50 V/us子类别:Operational Amplifier
供电电压上限:18 V标称供电电压 (Vsup):15 V
表面贴装:YES技术:BIPOLAR
温度等级:COMMERCIAL端子面层:Matte Tin (Sn)
端子形式:GULL WING端子节距:1.27 mm
端子位置:DUAL处于峰值回流温度下的最长时间:NOT SPECIFIED
标称均一增益带宽:23000 kHz宽度:3.9 mm

LT1216 数据手册

 浏览型号LT1216的Datasheet PDF文件第2页浏览型号LT1216的Datasheet PDF文件第3页浏览型号LT1216的Datasheet PDF文件第4页浏览型号LT1216的Datasheet PDF文件第5页浏览型号LT1216的Datasheet PDF文件第6页浏览型号LT1216的Datasheet PDF文件第7页 
LT1215/LT1216  
23MHz, 50V/µs, Single Supply  
Dual and Quad  
Precision Op Amps  
U
DESCRIPTIO  
FEATURES  
Slew Rate: 50V/µs Typ  
TheLT®1215isadual,singlesupplyprecisionopampwith  
a 23MHz gain-bandwidth product and a 50V/µs slew rate.  
The LT1216 is a quad version of the same amplifier. The  
DC precision of the LT1215/LT1216 eliminates trims in  
most systems while providing high frequency perfor-  
mance not usually found in single supply amplifiers.  
Gain-Bandwidth Product: 23MHz Typ  
Fast Settling to 0.01%  
2V Step to 200µV: 250ns Typ  
10V Step to 1mV: 480ns Typ  
Excellent DC Precision in All Packages  
Input Offset Voltage: 450µV Max  
Input Offset Voltage Drift: 10µV/°C Max  
Input Offset Current: 120nA Max  
Input Bias Current: 600nA Max  
Open-Loop Gain: 1000V/mV Min  
The LT1215/LT1216 will operate on any supply greater  
than 2.5V and less than 36V total. These amplifiers are  
specified on single 3.3V, single 5V and ±15V supplies, and  
only require 5mA of quiescent supply current per ampli-  
fier. The inputs can be driven beyond the supplies without  
damage or phase reversal of the output. The minimum  
output drive is 30mA, ideal for driving low impedance  
loads.  
Single Supply Operation  
Input Voltage Range Includes Ground  
Output Swings to Ground While Sinking Current  
Low Input Noise Voltage: 12.5nV/Hz Typ  
U
Low Input Noise Current: 0.5pA/Hz Typ  
APPLICATIO S  
Specified on 3.3V, 5V and ±15V  
Large Output Drive Current: 30mA Min  
2.5V Full-Scale 12-Bit Systems: VOS 0.75 LSB  
Low Supply Current per Amplifier: 6.6mA Max  
10V Full-Scale 16-Bit Systems: VOS 3 LSB  
Dual in 8-Pin DIP and SO-8  
Active Filters  
Photo Diode Amplifiers  
Quad in 14-Pin DIP and NARROW SO-16  
DAC Current to Voltage Amplifiers  
Note: For applications requiring less slew rate, see the LT1211/LT1212 and  
LT1213/LT1214 data sheets.  
Battery-Powered Systems  
, LTC and LT are registered trademarks of Linear Technology Corporation.  
U
TYPICAL APPLICATIO  
Single Supply Instrumentation Amplifier  
Frequency Response  
30  
5V  
0.1µF  
20  
NOTE:  
DIFFERENTIAL INPUT  
V
+
IN  
10  
0.1% RESISTORS GIVE CMRR 68dB.  
GAIN IS 10.0V/V.  
COMMON MODE INPUT RANGE  
IS FROM 0.3V TO 3.0V.  
BANDWIDTH IS 2.8MHz.  
1/2  
LT1215  
0
–10  
–20  
–30  
–40  
–50  
–60  
–70  
113Ω  
1020Ω  
113Ω  
1020Ω  
COMMON MODE INPUT  
1/2  
LT1215  
V
OUT  
1k  
10k  
100k  
1M  
10M  
+
V
IN  
+
FREQUENCY (Hz)  
1215/16 TA01  
1215/16 TA02  
1

与LT1216相关器件

型号 品牌 描述 获取价格 数据表
LT1216_15 Linear 23MHz, 50V/s, Single Supply Dual and Quad Precision Op Amps

获取价格

LT1216C Linear 23MHz, 50V/us, Single Supply Dual and Quad Precision Op Amps

获取价格

LT1216CN Linear 23MHz, 50V/us, Single Supply Dual and Quad Precision Op Amps

获取价格

LT1216CN14 Linear IC QUAD OP-AMP, 650 uV OFFSET-MAX, 23 MHz BAND WIDTH, PDIP14, Operational Amplifier

获取价格

LT1216CS Linear 23MHz, 50V/us, Single Supply Dual and Quad Precision Op Amps

获取价格

LT1216CS#PBF Linear LT1216 - 23MHz, 50V/µs, Single Supply Quad Precision Op Amps; Package: SO; Pins:

获取价格