Inductors(coils)/Microchip Transformer > Chip Inductors (Chip Coils) > for DC-DC Converter Wire Wound Type
Data Sheet
2
Continued from the preceding page.
I Inductance - Frequency Characteristics (Typ.)
I Inductance - Current Characteristics (Typ.)
100
10
1
1000
22µH
22µH
10µH
6.8µH
10µH
6.8µH
100
4.7µH
3.3µH
4.7µH
3.3µH
2.2µH
1.0µH
10
1
2.2µH
1.0µH
0.1
0.1
0.1
1
10
100
1000
10
100
DC Current (mA)
1000
10000
Frequency (MHz)
I !Caution/Notice
!Caution (Rating)
Notice
Do not use products beyond the rated current as
this may create excessive heat.
Solderability of Tin plating termination chip might be
deteriorated when low temperature soldering profile
where peak solder temperature is below the Tin melting
point is used. Please confirm the solderability of Tin
plating termination chip before use.
o This data sheet is applied for CHIP INDUCTORS (CHIP COILS) used for General Electronics equipment for your design.
!
Note:
1. This datasheet is downloaded from the website of Murata Manufacturing co., ltd. Therefore, it’s specifications are subject to change or our
products in it may be discontinued without advance notice. Please check with our sales representatives or product engineers before ordering.
2. This datasheet has only typical specifications because there is no space for detailed specifications. Therefore, please approve our product
specifications or transact the approval sheet for product specifications before ordering.
2009.1.8
http://www.murata.com/