5秒后页面跳转
LMC567CN PDF预览

LMC567CN

更新时间: 2024-02-15 01:05:23
品牌 Logo 应用领域
美国国家半导体 - NSC 解码器电信集成电路电信信令电路电信电路光电二极管
页数 文件大小 规格书
7页 172K
描述
Low Power Tone Decoder

LMC567CN 技术参数

是否Rohs认证: 不符合生命周期:Obsolete
包装说明:SOP, SOP8,.25Reach Compliance Code:unknown
风险等级:5.92JESD-30 代码:R-PDSO-G8
JESD-609代码:e0端子数量:8
最高工作温度:125 °C最低工作温度:-25 °C
封装主体材料:PLASTIC/EPOXY封装代码:SOP
封装等效代码:SOP8,.25封装形状:RECTANGULAR
封装形式:SMALL OUTLINE认证状态:Not Qualified
子类别:PLL or Frequency Synthesis Circuits表面贴装:YES
技术:CMOS温度等级:OTHER
端子面层:Tin/Lead (Sn/Pb)端子形式:GULL WING
端子节距:1.27 mm端子位置:DUAL
Base Number Matches:1

LMC567CN 数据手册

 浏览型号LMC567CN的Datasheet PDF文件第1页浏览型号LMC567CN的Datasheet PDF文件第2页浏览型号LMC567CN的Datasheet PDF文件第3页浏览型号LMC567CN的Datasheet PDF文件第5页浏览型号LMC567CN的Datasheet PDF文件第6页浏览型号LMC567CN的Datasheet PDF文件第7页 
Typical Performance Characteristics  
Supply Current vs.  
Operating Frequency  
Bandwidth vs.  
Input Signal Level  
Largest Detection  
Bandwidth vs. Temp.  
DS008670-3  
DS008670-7  
DS008670-8  
Bandwidth as  
a Function of C2  
Frequency Drift  
with Temperature  
Frequency Drift  
with Temperature  
DS008670-10  
DS008670-9  
DS008670-11  
Applications Information (refer to Block  
Diagram)  
This equation is accurate at low frequencies; however,  
GENERAL  
=
above 50 kHz (Fosc 100 kHz), internal delays cause the  
The LMC567 low power tone decoder can be operated at  
supply voltages of 2V to 9V and at input frequencies ranging  
from 1 Hz up to 500 kHz.  
actual frequency to be lower than predicted.  
The choice of Rt and Ct will be a tradeoff between supply  
current and practical capacitor values. An additional supply  
current component is introduced due to Rt being switched to  
Vs every half cycle to charge Ct:  
The LMC567 can be directly substituted in most LM567 ap-  
plications with the following provisions:  
1. Oscillator timing capacitor Ct must be halved to double  
the oscillator frequency relative to the input frequency  
(See OSCILLATOR TIMING COMPONENTS).  
=
Is due to Rt Vs/(4Rt)  
Thus the supply current can be minimized by keeping Rt as  
large as possible (see supply current vs. operating fre-  
quency curves). However, the desired frequency will dictate  
an RtCt product such that increasing Rt will require a smaller  
2. Filter capacitors C1 and C2 must be reduced by a factor  
of 8 to maintain the same filter time constants.  
3. The output current demanded of pin 8 must be limited to  
the specified capability of the LMC567.  
=
Ct. Below Ct 100 pF, circuit board stray capacitances be-  
gin to play a role in determining the oscillation frequency  
which ultimately limits the minimum Ct.  
OSCILLATOR TIMING COMPONENTS  
To allow for I.C. and component value tolerances, the oscil-  
lator timing components will require a trim. This is generally  
accomplished by using a variable resistor as part of Rt, al-  
though Ct could also be padded. The amount of initial fre-  
quency variation due to the LMC567 itself is given in the  
electrical specifications; the total trim range must also ac-  
commodate the tolerances of Rt and Ct.  
The voltage-controlled oscillator (VCO) on the LMC567 must  
be set up to run at twice the frequency of the input signal  
tone to be decoded. The center frequency of the VCO is set  
by timing resistor Rt and timing capacitor Ct connected to  
pins 5 and 6 of the IC. The center frequency as a function of  
Rt and Ct is given by:  
Since this will cause an input tone of half Fosc to be decoded,  
www.national.com  
4

与LMC567CN相关器件

型号 品牌 描述 获取价格 数据表
LMC567CN/NOPB NSC IC TELECOM, TONE DECODER CIRCUIT, PDIP8, PLASTIC, DIP-8, Telecom Signaling Circuit

获取价格

LMC567CN/NOPB TI Low-Power Tone Decoder

获取价格

LMC568 NSC Low Power Phase-Locked Loop

获取价格

LMC568CM NSC Low Power Phase-Locked Loop

获取价格

LMC568CMX ETC Analog Phase-Locked Loop

获取价格

LMC568CMX/NOPB NSC IC PHASE LOCKED LOOP, PDSO8, M08A, PLL or Frequency Synthesis Circuit

获取价格