October 22, 2011
LM5064
Negative Voltage System Power Management and
Protection IC with PMBus
General Description
Features
The LM5064 combines a high performance hot swap con-
troller with a PMBusTM compliant SMBus/I2C interface to ac-
curately measure, protect and control the electrical operating
conditions of systems connected to a backplane power bus.
The LM5064 continuously supplies real-time power, voltage,
current, temperature and fault data to the system manage-
ment host via the SMBus interface.
Input voltage range: -10V to -80V
■
■
Programmable 26 mV or 50 mV current limit threshold with
power limiting (MOSFET power dissipation limiting)
Real time monitoring of VIN, VOUT, IIN, PIN, VAUX with 12-bit
resolution and 1 kHz sampling rate
■
Configurable circuit breaker protection for hard shorts
Configurable under-voltage and over-voltage protection
■
■
■
The LM5064 control block includes a unique hot swap archi-
tecture that provides current and power limiting to protect
sensitive circuitry during insertion of boards into a live system
backplane, or any other "hot" power source. A fast acting cir-
cuit breaker prevents damage in the event of a short circuit
on the output. The input under-voltage and over-voltage lev-
els and hysteresis are configurable, as well as the insertion
delay time and fault detection time. A temperature monitoring
block on the LM5064 interfaces with a low-cost external diode
for monitoring the temperature of the external MOSFET or
other thermally sensitive components. The PGD output pro-
vides a fast indicator when the input and/or output voltages
are outside their programmed ranges.
Remote temperature sensing with programmable warning
and shutdown thresholds
Detection and notification of damaged MOSFET condition
Power measurement accuracy: ±4.5% over temperature
True input power averages dynamic power readings
■
■
■
■
Averaging of VIN, IIN, PIN, and VOUT over programmable
interval ranging from 0.001 to 4 seconds
Programmable WARN and FAULT thresholds with
SMBA notification
Black box capture of telemetry measurements and device
status triggered by WARN or FAULT condition
I2C/SMBus interface and PMBus compliant command
structure
■
■
■
The LM5064 monitoring circuit computes both the real-time
and average values of subsystem operating parameters
(VIN, IIN, PIN, VOUT) as well as the peak power. Accurate power
averaging is accomplished by averaging the product of the
input voltage and current. A black box (Telemetry/Fault Snap-
shot) function captures and stores telemetry data and device
status in the event of a warning or a fault.
Full featured application development software
eTSSOP-28 package
■
■
Applications
Base Station Power Distribution Systems
■
■
■
Intelligent Solid State Circuit Breaker
-24V/-48V Industrial Systems
Typical Application Circuit
301584001
© 2012 Texas Instruments Incorporated
301584 SNVS718C
www.ti.com