Electrical Characteristics VDD = 3V (Notes 2, 3)
The following specifications apply for VDD = 3V and RL = 8Ω unless otherwise specified. Limits apply for TA
=
25˚C. (Continued)
LM4991
Symbol
Parameter
Conditions
Typical
Limit
Units
(Note 7)
(Note 8)
(Limits)
PSRR
Power Supply Rejection
Ratio
VRIPPLE = 200mV sine p-p,
Input terminated with 10Ω,
f = 1kHz
68
dB
Electrical Characteristics VDD = 2.6V (Notes 2, 3)
The following specifications apply for VDD = 2.6V and RL = 8Ω unless otherwise specified. Limits apply for TA = 25˚C.
LM4991
Symbol
Parameter
Conditions
VIN = 0V, no Load
Typical
(Note 7)
Limit
(Note 8)
Units
(Limits)
Quiescent Power Supply
Current
2
3
IDD
mA (max)
VIN = 0V, RL = 8Ω
ISD
Shutdown Current
VSHUTDOWN = VDD
0.1
1
µA(max)
VSDIH
VSDIL
VOS
Shutdown Voltage Input High
Shutdown Voltage Input Low
Output Offset Voltage
V
V
0.9
5
35
mV (max)
THD = 1% (max), f = 1kHz
RL = 4Ω
RL = 8Ω
Po
Output Power
400
300
mW
%
Total Harmonic
Distortion+Noise
Power Supply Rejection
Ratio
THD+N
PSRR
PO = 0.15W, f = 1kHz
0.1
VRIPPLE = 200mV sine p-p,
Input terminated with 10Ω,
f = 1kHz
51
dB
Note 2: Absolute Maximum Ratings indicate limits beyond which damage to the device may occur. Operating Ratings indicate conditions for which the device is
functional, but do not guarantee specific performance limits. Electrical Characteristics state DC and AC electrical specifications under particular test conditions which
guarantee specific performance limits. This assumes that the device is within the Operating Ratings. Specifications are not guaranteed for parameters where no limit
is given, however, the typical value is a good indication of device performance.
Note 3: All voltages are measured with respect to the ground pin, unless otherwise specified.
Note 4: The maximum power dissipation must be derated at elevated temperatures and is dictated by T
, θ , and the ambient temperature T . The maximum
A
JMAX JA
allowable power dissipation is P
= (T
–T )/θ or the number given in Absolute Maximum Ratings, whichever is lower. For the LM4991, T
= 150˚C.
DMAX
JMAX
A
JA
JMAX
For the θ ’s for different packages, please see the Application Information section or the Absolute Maximum Ratings section.
JA
Note 5: Human body model, 100pF discharged through a 1.5kΩ resistor.
Note 6: Machine Model, 220pF–240pF discharged through all pins.
Note 7: Typicals are specified at 25˚C and represent the parametric norm.
Note 8: Limits are guaranteed to National’s AOQL (Average Outgoing Quality Level).
2
Note 9: The given θ is for an LM4991 packaged in an LDC08A with the Exposed–DAP soldered to an exposed 1in area of 1oz printed circuit board copper.
JA
Note 10: When driving 3Ω or 4Ω loads from a 5V supply, the LM4991LD must be mounted to a circuit board.
www.national.com
4