Electrical Characteristics (Notes 2, 8) (Continued)
The following specifications apply for VDD= 3.0V, TA= 25˚C unless otherwise specified.
Symbol
Parameter
Conditions
LM4856
Units
(Limits)
Typical
(Note 5)
Limits
(Notes 6,
11)
Input referred minimum gain
Input referred maximum gain
Input referred minimum gain
Input referred maximum gain
-34.5
12.0
-40.5
6.0
-35.1
-33.9
11.4
12.6
-41.1
-39.9
5.4
dB (min)
dB (max)
dB (min)
dB (max)
dB (min)
dB (max)
dB (min)
dB (max)
dB
Digital Volume Range
(RIN and LIN
)
Digital Volume Range
(Phone_In_HS)
6.6
Digital Volume Stepsize
Digital Volume Stepsize Error
Phone_In_IHF Volume
1.5
0.1
12
0.6
11.4
12.6
dB ( max)
dB (min)
dB (max)
dB
BTL gain from Phone_In _IHF to
SPKROUT
Phone _In_IHF Mute Attenuation Output Mode 2, 4, 6
Phone_In_IHF Input Impedance
100
20
15
25
kΩ (min)
kΩ (max)
kΩ (min)
kΩ (max)
kΩ (min)
kΩ (max)
kΩ (min)
kΩ (max)
kΩ (min)
kΩ (max)
˚C (min)
µs (min)
ns (min)
ns (min)
ns (min)
ns (min)
Maximum gain setting
33.5
100
20
25
42
Phone_In_HS Input Impedance
Mininum gain setting
75
125
15
Maximum gain setting
25
RIN and LIN Input Impedance
Mininum gain setting
100
170
75
125
150
2.5
100
0
TSD
t1
Thermal Shutdown Temperature
SCL (Clock) Period
t2
SDA to SCL Set-up Time
Data Out Stable Time
Start Condition Time
t3
t4
100
100
t5
Stop Condition Time
Note 2: Absolute Maximum Rating indicate limits beyond which damage to the device may occur.
Note 3: Operating Ratings indicate conditions for which the device is functional, but do not guarantee specific performance limits. For guaranteed specifications and
test conditions, see the Electrical Characteristics. The guaranteed specifications apply only for the test conditions listed. Some performance characteristics may
degrade when the device is not operated under the listed test conditions.
Note 4: Human body model, 100pF discharged through a 1.5kΩ resistor.
Note 5: Typical specifications are specified at +25˚C and represent the most likely parametric norm.
Note 6: Tested limits are guaranteed to National’s AOQL (Average Outgoing Quality Level).
Note 7: Machine Model ESD test is covered by specification EIAJ IC-121-1981. A 200pF cap is charged to the specified voltage, then discharged directly into the
IC with no external series resistor (resistance of discharge path must be under 50Ω).
Note 8: All voltages are measured with respect to the ground pin, unless otherwise specified.
2
Note 9: The given θ and θ are for an LM4856 mounted on a demonstration board with a 4in area of 1oz printed circuit board copper ground plane.
JA
JC
Note 10: Please refer to the Output Noise vs Output Mode table in the Typical Performance Characteristics section for more details.
Note 11: Datasheet min/max specification limits are guaranteed by design, test, or statistical analysis.
www.national.com
6